RF2460PCBA-41X(V2) Ver la hoja de datos (PDF) - RF Micro Devices

Número de pieza

componentes Descripción

Lista de partido

RF2460PCBA-41X
(Rev.:V2)

PCS CDMA LOW NOISE AMPLIFIER/MIXER 1500MHz TO 2200MHz DOWNCONVERTER

RF Micro Devices 

RF2460

Output Interface Network of the Mixer

L1, C1, C2, and R form a current combiner which performs a differential to single-ended conversion at the IF frequency

and sets the output impedance. In most cases, the resonance frequency is independent of R and can be set according to

the following equation:

fIF

=

-----------------------------1------------------------------

2π

L----1--

2

(

C1

+

2C2

+ CEQ)

Where CEQ is the equivalent stray capacitance and capacitance looking into pins 7 and 9. An average value to use for

CEQ is 2.5pF.

R can then be used to set the output impedance according to the following equation:

R

=

⎛

⎝

----------1----------

4 ⋅ ROUT

–

-R-1--P--⎠⎞

–1

where ROUT is the desired output impedance and RP is the parasitic equivalent parallel resistance of L1.

C2 should first be set to 0 and C1 should be chosen as high as possible (suggested less than 20pF), while maintaining

an RP of L1 that allows for the desired ROUT. If the self-resonant frequencies of the selected C1 produce unsatisfactory

linearity performance, their values may be reduced and compensated for by including C2 capacitor with a value chosen

to maintain the desired FIF frequency.

L2 and C3 serve dual purposes. L2 serves as an output bias choke, and C3 serves as a series DC block.

In addition, L2 and C3 may be chosen to form an impedance matching network if the input impedance of the IF filter is

not equal to ROUT. Otherwise, L2 is chosen to be large (suggested 120nH) and C3 is chosen to be large (suggested

22nF) if a DC path to ground is present in the IF filter, or omitted if the filter is DC blocked.

8-88

Rev B5 060921

Share Link: