XE1414C(2000) Ver la hoja de datos (PDF) - Xecom
Número de pieza
componentes Descripción
Lista de partido
XE1414C Datasheet PDF : 17 Pages
| |||
XE1414C Modem Registers
S0 Answer on nth Ring: S0 sets the modem to auto-
matically answer on the nth ring. Setting S0 to 0
disables automatic answer.
Range: 0 to 255
Units
Rings
Default 0
S7 Wait for Carrier after Dialing: S7 determines how
long the modem waits for a valid carrier signal after
dialing is completed.
Range: 1 to 255
Units
Seconds
Default 50
S1 Ring Count: S1 is a read-only register showing the
S8 Comma Pause Time: S8 defines the duration of the
number of rings detected. If a ring is not detected
pause initiated by a comma in the dialing string. The
within 8 seconds, S1 is reset to zero.
pause is generally used when waiting for a second dial
Range: 0 to 255
tone.
Units
Rings
Range: 1 to 255
Default 0
Units
Seconds
Default 2
S2 Escape Character: S2 sets the ASCII escape
character. Values of 0-127 select valid ASCII escape S9 Reserved:
characters; values from 128 to 255 disable the escape
sequence.
S10 Carrier Off Disconnect Delay: S10 selects how long
Range: 0 to 255
carrier must be lost before the modem disconnects.
Units
ASCII Character
Note: If the value of S10 is smaller than the value of
Default 43 (+)
S9, the modem will not automatically disconnect on
loss of carrier.
S3 Carriage Return Character: S3 determines the
Range: 1 to 255
ASCII character to serve as a carriage return to
Units 0.1 Seconds
terminate commands and modem responses.
Default 14
Range: 0 to 127
Units
ASCII Character
S11 Tone Dialing Speed: S11 sets the duration and
Default 13 (Carriage Return)
spacing of the dialing tones. S11 does not affect the
pulse dialing rate.
S4 Line Feed Character: S4 sets the ASCII character to
Range: 50 to 255
act as a line feed character in modem responses.
Units 1 Millisecond
Range: 0 to 127
Default 95
Units
ASCII Character
Default 10 (Line Feed)
S12 Escape Code Guard Timer: S12 sets the escape
S5 Back Space Character: S5 defines the ASCII
character used as a backspace to edit the command
line.
Range: 0 to 32
Units
ASCII Character
Default 8 (Back Space)
sequence guard timer. If characters are received before
or after the escape sequence, within the guard timer, the
modem aborts the escape attempt and remains in data
mode.
Range: 0 to 255
Units
0.02 Seconds
Default 50
S6 Dial Tone Wait Time: S6 determines how long the
modem waits for dial tone before dialing begins. The
Dial Tone Wait Time cannot be set to less than two
seconds.
Range: 2 to 255
Units
Seconds
Default 2
XECOM
(11)
XE1414C
Share Link: 