TSM102(2004) Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Lista de partido

TSM102
(Rev.:2004)

VOLTAGE AND CURRENT CONTROLLER

STMicroelectronics 

TSM102/A

Notes:

The current control values must be chosen in ac-

cordance with the elements of the primary side.

The performances of the battery charger in their

globality are highly dependent on the adequation

of the primary and the secondary elements.

The addition of the diode D9 is necessary to avoid

dramatic discharge of the battery cells in case of

the charger disconnection from the mains voltage,

and therefore, the voltage measurement is to be

operated on the cathode side of the diode not to

take its voltage drop into account. The total bridge

value of R1, R2, R3 must ensure low battery dis-

charge if the charger is disconnected from main,

but remains connected to the battery by mistake.

The chosen values impose a 44µA discharge cur-

rent max.

R12 and R13 are the equivalent resistors seen

from the opamp and from the comparator.

A hysteresis resistor can be connected to the “End

Of Charge” comparator to ensure proper hystere-

sis to this signal, but this resistor must be chosen

carefully not to degrade the output voltage preci-

sion. It might be needed to impose unidirectionnal

hysteresis (by inserting a diode on the positive

feedback of the comparator).

Figure 3 shows how to use the integrated Voltage

Reference to build a precise Power Supply for the

TSM102A (and other components if necessary).

Pin 8 remains the reference for all voltage mea-

surements for the rest of the application.

Figure 3 : A precise power supply for the TSM102A and other components

Vaux

Vcc

+

Vaux

9

+

8

13

TSM102 Vref

8/9

Share Link: