DC9325 Ver la hoja de datos (PDF) - Unspecified

Número de pieza

componentes Descripción

Lista de partido

DC9325

OIL AND GAS PRODUCTION AND TRANSMISSION PIPELINES AND SYSTEMS

Unspecified 

PRECAUTIONARY STATEMENTS

HAZARDS TO HUMANS AND DOMESTIC ANIMALS

DANGER. Keep Out of Reach of Children. Corrosive. Causes irreversible eye damage

and skin burns. Harmful if swallowed, absorbed through the skin or inhaled. Avoid

breathing spray mist. Do not get into eyes, on skin or on clothing. Wash thoroughly with

soap and water after handling and before eating, drinking, using tobacco or using the toilet.

Remove and wash contaminated clothing before reuse. Wear goggles or face shield and

rubber gloves and protective clothing when handling.

ENVIRONMENTAL HAZARD

This pesticide is toxic to fish. Do not discharge effluent containing this product into lakes,

streams, ponds, estuaries, oceans or other waters unless in accordance with the

requirements of a National Pollutant Discharge Elimination System (NPDES) permit and

the permitting authority has been notified in writing prior to discharge. Do not discharge

effluent containing this product into sewer systems without previously notifying the local

sewage treatment plant authority. For guidance contact your State Water Board or

Regional Office of the EPA.

PHYSICAL OR CHEMICAL HAZARDS

Do not use or store near heat or open flame. Do not mix with oxidizers, anionic soaps and

detergents.

PELIGRO: SI NO PUEDE LEER EN INGLES, PREGUNTE A SU SUPERVISOR SOBRE

LAS INSTRUCCIONES DE USO APROPIADAS ANTES DE TRABAJAR CON ESTE

PRODUCTO.

DANGER: IF YOU CANNOT READ ENGLISH, ASK YOUR SUPERVISOR TO EXPLAIN

THE APPROPRIATE DIRECTIONS FOR USE BEFORE WORKING WITH THIS

PRODUCT.

NOBAC DC 9325

ACTIVE INGREDIENTS:

Glutaraldehyde

Alkyl (50%C14,40%C12,10%C16)

dimethyl benzyl ammonium chloride

Didecyl dimethyl ammonium chloride

INERT INGREDIENTS:

TOTAL:

25.7%

5.0%

7.5%

61.8%

100.00%

KEEP OUT OF REACH OF CHILDREN

DANGER PELIGRO

See side panel for additional precautionary statements.

EPA Reg. No. 10324-185-75713

EPA Est. No. 75713-OK-001

DIRECTIONS FOR USE

It is a violation of Federal Law to use NOBAC DC 9325 in a manner inconsistent with its

labeling.

FRAC FLUIDS: NOBAC DC 9325 reduces bacterial contamination and degradation of

fracturing fluids and gels used in oil and gas well stimulations. Add NOBAC DC 9325 to the

frac water storage tanks or directly into the well head injection pipeline as the water is being

pumped down-hole.

Dose Range: NOBAC DC 9325 is added at a rate 50 to 2950 ppm on an actives bases

(1.31 to 77.23 gallons per 10,000 gallons), depending on the degree of bacterial fouling in

the source water.

WATER FLOODS: NOBAC DC 9325 is added to a water flood system at a point of

uniform mixing.

Initial Treatment: When the system is noticeably contaminated, add 50 to 2500 ppm on an

actives basis of NOBAC DC 9325 to the system (0.13 to 6.54 gallons of NOBAC DC 9325

per 1,000 gallons flood water). Repeat until control is achieved.

Subsequent Dose: When microbial control is evident, add 10 to 2500 ppm on an actives

basis of NOBAC DC 9325 (0.03 to 6.54 gallons of NOBAC DC 9325 per 1,000 gallons flood

water) to the system weekly, or as needed to maintain control.

DRILLING, COMPLETION, AND WORKOVER FLUIDS: NOBAC DC 9325 is added

to a drilling fluid system at a point of uniform mixing such as the circulating mud tank.

Initial Treatment: Add 25 to 500 ppm on an actives basis of NOBAC DC 9325 (0.27 to 5.50

gallons of this product per 100 barrels of fluid) to a freshly prepared fluid depending on the

severity of contamination.

Maintenance Dose: Maintain a concentration of 25 to 500 ppm on an actives basis of

NOBAC DC 9325 by adding 0.27 to 5.50 gallons of NOBAC DC 9325 per 100 barrels of

additional fluid, or as needed, depending on the severity of contamination.

PACKER FLUIDS: NOBAC DC 9325 is added to a packer fluid at a point of uniform

mixing such as circulating holding tank. Add 25 to 300 ppm on an actives basis of NOBAC

DC 9325 (0.27 to 3.30 gallons of NOBAC DC 9325 per 100 barrels of fluid) to a freshly

prepared fluid depending on the severity of contamination. Seal treated packer fluid in the

wall between the casting and production tube.

FIRST AID

Have the product container or label with you when calling a poison control center or doctor, or

going for treatment.

IF ON SKIN OR CLOTHING: Take off contaminated clothing. Rinse skin immediately with plenty

of water for 15-20 minutes. Call a poison control center or doctor for treatment advice.

IF IN EYES: Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove

contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a poison control

center or doctor for treatment advice

IF SWALLOWED: Call a poison control center or doctor immediately for treatment advice. Have

person sip a glass of water if able to swallow. Do not induce vomiting unless told to do so by a

poison control center or doctor. Do not give anything by mouth to an unconscious person.

IF INHALED: Move person to fresh air. If person is not breathing, call 911 or an ambulance, then

give artificial respiration, preferably mouth-to-mouth, if possible. Call a poison control center or

doctor for further treatment advice.

NOTE TO PHYSICIAN: Probable mucosal damage may contraindicate the use of gastric lavage.

Sold By:

DANLIN INDUSTRIES CORPORATION

P.O. Box 307

Thomas, OK 73669-0307

(580) 661-3248

NET CONTENTS:

□ 55 Gallons

□ 275 gallons

OIL AND GAS PRODUCTION AND TRANSMISSION PIPELINES AND

SYSTEMS: NOBAC DC 9325 is added to an oil/gas production or transmission line

via direct injection. The application is conducted to ensure maximum distribution of this

product throughout the entire internal pipeline surface by adding a sufficient amount of

biocide to detect/measure a residual concentration at the back end of the pipeline

system. Criteria for success of the treatment will be a reduction in bacterial counts

and/or reduced corrosion rates. To facilitate application, it may be desirable to dilute

NOBAC DC 9325 with an appropriate solvent immediately before use. The

concentration in the solvent must not fall below an active concentration range of 500 to

5,000 ppm based on the volume of water in the pipeline. Injections to the system are

made weekly, or as needed to maintain control.

GAS STORAGE WELLS AND SYSTEMS: Individual injection wells are treated

with a sufficient quantity of NOBAC DC 9325 to produce a concentration of 1,500 to

15,000 ppm of NOBAC DC 9325 when diluted by the water present in the formation.

Injection takes place before gas is injected during the summer. Injections should be

repeated yearly, or as needed to maintain control.

Individual drips should be treated with a sufficient quantity of NOBAC DC 9325 to

produce a concentration of 600 to 6000 ppm of NOBAC DC 9325 when diluted by the

water present in the drip. Injections should be repeated yearly or as needed to maintain

control.

HYDROTESTING: Water used to hydrotest pipelines or vessels should contain 50 to

2,000 ppm on an actives basis of NOBAC DC 9325 (0.13 to 5.24 gallons of NOBAC

DC 9325 per 1,000 gallons water) depending on the water quality and length of time

the equipment remains idle.

PIPELINE PIGGING AND SCRAPING OPERATIONS: Add NOBAC DC 9325

to a slug of water immediately following the scraper. Ideally this water volume can be

kept to a minimum and contained between the scraper and a trailing pig. Sufficient

product is added to produce a concentration of 0.13 to 1.3% (0.13 to 1.3 gallons of

NOBAC DC 9325 per 100 gallons of water), depending on the length of the pipeline

and the severity of biofouling.

STORAGE AND DISPOSAL

Do not contaminate water, food, or feed by storage and disposal.

PESTICIDE STORAGE: Open dumping is prohibited. Store only in original container.

Do not reuse empty container. If a leaky container must be contained within another,

mark the outer container to identify the contents. Store pesticides away from food, pet

food, feed, seed, fertilizers, and veterinary supplies. Keep this product under locked

storage sufficient to make it inaccessible to children or persons unfamiliar with its

proper use.

PESTICIDE DISPOSAL: Pesticide wastes are acutely hazardous. Improper disposal of

excess pesticide, spray mixture or rinsate is a violation of Federal Law. If these wastes

cannot be disposed of by use according to label instructions, contact your State

Pesticide or Environmental Control Agency, or the Hazardous Waste Representative at

the nearest EPA Regional Office for guidance.

CONTAINER HANDLING DISPOSAL: Non-refillable container. Do not reuse this

container to hold materials other than pesticides or rinsate. Offer for recycling if

available or puncture and dispose in a sanitary landfill, or by other procedures

approved by state and local authorities. If rinsate cannot be used, follow pesticide

disposal instructions. If not triple rinsed, these containers are acute hazardous wastes

and must be disposed in accordance with local, state and federal regulations.

RESIDUE REMOVAL INSTRUCTIONS: Triple rinse container promptly after emptying.

Triple rinse as follows: Empty remaining contents into application equipment or a mix

tank. Fill the container ¼ full with water. Replace and tighten closures. Tip container on

its side and roll it back and forth, ensuring at least one complete revolution, for 30

seconds. Stand the container on its end and tip it back and forth several times. Turn

the container over onto its other end and tip it back and forth several times. Empty the

rinsate into application equipment or a mix tank or store for later use or disposal.

Repeat this procedure two more times.

Lot #:

DIRECTIONS FOR USE (Continued)

Share Link: