TP3201 Ver la hoja de datos (PDF) - Topro

Número de pieza

componentes Descripción

Lista de partido

TP3201

1cell Li-ion battery Protector IC

Topro 

TP3201

1cell Li-ion battery

Protector IC

General Specification

The TP3201 series are protection IC for over-charge/discharge of rechargeable one-cell Lithium-ion

(Li+) batteries by CMOS process.

The TP3201 series can detect over-charge/discharge of Li+ one-cell and excess load current, further

include a short circuit protector for preventing large external short circuit current.

Each of these ICs is composed of three voltage detectors, a reference unit, a hysteresis circuit, and a

short circuit protector. When charging voltage crosses the detector threshold from a low value to a value

higher than VDET1, the output of COUT pin, the output of over-charge detector/VD1, switches to low

level, charger's negative pin level. After detecting overcharge the VD1 can be reset and the output of

COUT pin becomes "H" when the VDD voltage is coming down to a level lower than ' VDET1 – VHYS1

", or when a charger is disconnected from the battery pack while the VDD level is in between 'VDET1"

and ' VDET1 – VHYS1 " in the TP3201 version.

The output of DOUT pin, the output of over-discharge detector/VD2, switches to "L" after internally

fixed delay time passed, when discharging voltage crosses the detector threshold from a high value to a

value lower than VDET2. An excess load current can be sensed and cut off after internally fixed delay

time passed through the built in excess current detector, VD3, with DOUT being enabled to low level.

Once after detecting excess current, the VD3 is released and DOUT level switches to "H" by detaching a

battery pack from a load system.

Further, short circuit protector makes Dout level to "L" immediately with external short circuit current

and removing external short circuit leads DOUT level to "H". After detecting over-discharge, supply

current will be kept extremely "L" by halting some internal circuits operation. The output delay of over -

charge detectors can be set by connecting external capacitors. Output type of COUT and DOUT are

CMOS. SOT26-w is available.

Package Overcharge

Model

detection

SOT-26-W Voltage(V)

TP3201

101E

101F

4.35+0.05

4.35+0.05

Overcharge

detection

Hysteresis

voltage(mV)

200+50

200+50

Overdischarge Overcurrent

Detection

Detection

Voltage(V) Voltage(mV)

2.5

200+30

2.5

100+30

Page 2 of 12

TOPRO CONFIDNETIAL

2003/7/8 Print

Share Link: