MAX2016ETID(2004) Ver la hoja de datos (PDF) - Maxim Integrated

Número de pieza

componentes Descripción

Lista de partido

MAX2016ETID
(Rev.:2004)

LF-to-2.5GHz Dual Logarithmic Detector/Controller for Power, Gain, and VSWR Measurements

Maxim Integrated 

LF-to-2.5GHz Dual Logarithmic Detector/

Controller for Power, Gain, and VSWR Measurements

AC ELECTRICAL CHARACTERISTICS—OUTD (continued)

(Typical Application Circuit, VCC = +2.7V to +3.3V, R1 = R2 = R3 = 0Ω, TA = -40°C to +85°C, unless otherwise noted. Typical values

are at VCC = 3.3V, CSETL = CSETH = VCC, TA = +25°C, unless otherwise noted.) (Note 1)

PARAMETER

SYMBOL

CONDITIONS

MIN TYP MAX UNITS

Large-Signal Rise and Fall Time

±1dB Dynamic Range

Slope

OUTD Voltage Deviation

Any 30dB step, no external capacitor on

pins FV1 and FV2

0.1GHz

PRFINB = -32dBm

0.9GHz

PRFINB = -30dBm

1.9GHz

PRFINB = -27dBm

2.17GHz

PRFINB = -25dBm

2.5GHz

PRFINB = -23dBm

fRF = 0.1GHz to 2.5GHz

PRFINA = PRFINB = -30dBm, TA =

-20°C to +85°C

35

80

75

60

55

50

25

±0.25

ns

dB

mV/dB

dB

0.1GHz, PRFINB =

80

-32dBm

±1dB Dynamic Range over

Temperature Relative to Best-Fit

Curve at +25°C

PRFINA is swept ;

TA = -20°C to

+85°C

0.9GHz, PRFINB =

-30dBm

1.9GHz, PRFINB =

-27dBm

2.17GHz, PRFINB =

-25dBm

70

55

dB

50

2.5GHz, PRFINB =

-23dBm

45

Gain Measurement Balance

Channel Isolation

PRFINB = PRFINB = -50dBm to -5dBm, fRF =

0.2

dB

1.9GHz

0.9GHz

90

1.9GHz

65

dB

2.5GHz

55

Note 1: The MAX2016 is tested at TA = +25°C and is guaranteed by design for TA = -40°C to +85°C.

Note 2: Typical minimum and maximum range of the detector at the stated frequency.

Note 3: Dynamic range refers to the range over which the error remains within the ±3dB range.

Note 4: The slope is the variation of the output voltage per change in input power. It is calculated by fitting a root-mean-square

straight line to the data indicated by the RF input power range.

Note 5: The intercept is an extrapolated value that corresponds to the output power for which the output voltage is zero. It is calcu-

lated by fitting a root-mean-square straight line to the data.

_______________________________________________________________________________________ 5

Share Link: