MAX2014EUAT Ver la hoja de datos (PDF) - Maxim Integrated
Número de pieza
componentes Descripción
Lista de partido
MAX2014EUAT Datasheet PDF : 12 Pages
| |||
50MHz to 1000MHz, 75dB Logarithmic
Detector/Controller
ABSOLUTE MAXIMUM RATINGS
VCC (Pins 1, 4) to GND........................................-0.3V to +5.25V
SET, PWDN to GND....................................-0.3V to (VCC + 0.3V)
Input Power Differential INHI, INLO................................+23dBm
Input Power Single Ended (INHI or INLO grounded).....+19dBm
Continuous Power Dissipation (TA = +70°C)
TDFN (derate 18.5mW/°C above +70°C)....................1480mW
µMAX (derate 4.5mW/°C above +70°C) .......................362mW
Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature ......................................................+150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
Soldering Temperature (reflow) .......................................+260°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
PACKAGE THERMAL CHARACTERISTICS (Note 1)
TDFN:
Junction-to-Ambient Thermal Resistance (θJA) ............54°C/W
Junction-to-Case Thermal Resistance (θJC) ...................8°C/W
µMAX:
Junction-to-Ambient Thermal Resistance (θJA) ..........221°C/W
Junction-to-Case Thermal Resistance (θJC) .................42°C/W
Note 1: Package thermal resistances were obtained using the method described in JEDEC specification JESD51-7. For detailed
information on package thermal considerations, refer to www.maxim-ic.com/thermal-tutorial.
DC ELECTRICAL CHARACTERISTICS
(Typical Application Circuit (Figure 1), VS = +3.3V, fRF = 50MHz to 1000MHz, R1 = 0Ω, R4 = 0Ω, RL = 10kΩ, TA = -40°C to +85°C,
unless otherwise noted. Typical values are at TA = +25°C, unless otherwise noted.) (Note 2)
PARAMETER
POWER SUPPLY
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
Supply Voltage
R4 = 75Ω ±1%, PWDN must be
4.75
VS
connected to GND
R4 = 0Ω
2.7
5.25
V
3.6
Supply Current
Supply Current Variation with Temp
Shutdown Current
CONTROLLER REFERENCE (SET)
SET Input Voltage Range
SET Input Impedance
DETECTOR OUTPUT (OUT)
Source Current
Sink Current
Minimum Output Voltage
Maximum Output Voltage
ICC
ICC
ICC
VOUT(MIN)
VOUT(MAX)
TA = +25°C, VS = 5.25V,
R4 = 75Ω
TA = +25°C
TA = -40°C to +85°C
VPWDN = VCC
17.3
17.3
20.5
0.05
1
0.5 to 1.8
40
4
450
0.5
1.8
mA
mA/°C
µA
V
kΩ
mA
µA
V
V
2
Share Link: 