MAX8647ETE Ver la hoja de datos (PDF) - Maxim Integrated
Número de pieza
componentes Descripción
Lista de partido
MAX8647ETE Datasheet PDF : 15 Pages
| |||
Ultra-Efficient Charge Pumps for
Six White/RGB LEDs in 3mm x 3mm Thin QFN
Pin Description
PIN
MAX8647 MAX8648
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8–13
8–13
14
—
15
—
16
—
—
14, 15, 16
—
—
NAME
FUNCTION
Supply Voltage Input. The input voltage range is 2.7V to 5.5V. Bypass IN to GND with a
IN
1µF ceramic capacitor as close as possible to the IC. IN is high impedance during
shutdown. Connect IN to the anodes of all the LEDs.
GND
Ground. Connect GND to system ground and the input bypass capacitor as close as
possible to the IC.
C1P
Transfer Capacitor 1 Positive Connection. Connect a 1µF ceramic capacitor from C1P
to C1N.
C2P
Transfer Capacitor 2 Positive Connection. Connect a 1µF ceramic capacitor from C2P
to C2N.
C2N
Transfer Capacitor 2 Negative Connection. Connect a 1µF ceramic capacitor from C2P
to C2N. An internal 10kΩ resistor pulls C2N to GND during shutdown.
C1N
Transfer Capacitor 1 Negative Connection. Connect a 1µF ceramic capacitor from C1P
to C1N.
NEG
Charge-Pump Negative Output. Connect a 1µF ceramic capacitor from NEG to GND. In
shutdown, an internal 10kΩ resistor pulls NEG to GND. Connect the exposed paddle to
NEG directly under the IC.
LED6–LED1
LED Current Regulators. Current flowing into LED_ is based on the internal registers.
Connect LED_ to the cathodes of the external LEDs. LED_ is high impedance during
shutdown. For the MAX8647, program any unused LED_ to off and LED_ can be
shorted to ground or left unconnected. For the MAX8648, short any unused LED_ to IN
prior to power-up to disable the corresponding current regulator.
SDA
SCL
I2C Data Input. Data is read on the rising edge of SCL.
I2C Clock Input. Data is read on the rising edge of SCL.
VDD
Logic-Input Supply Voltage. Connect to the supply voltage driving SDA and SCL.
Bypass VDD to GND with a 0.1µF ceramic capacitor.
ENC, ENB, ENA
Enable and Serial-Pulse Dimming Control. ENA controls LED1, LED2, and LED3. ENB
controls LED4 and LED5. ENC controls LED6. Drive EN_ logic-high to turn on the IC
and enable the corresponding LED_ at 24mA each. Drive an individual EN_ logic-low
for greater than 4ms to turn off the corresponding-current regulators or drive all three
EN_ low to place the IC in shutdown. See the Serial-Pulse Dimming Control (MAX8648)
section.
EP
Exposed Paddle. Connect to NEG.
_______________________________________________________________________________________ 7
Share Link: 