CS5510-ASZ(2009) Ver la hoja de datos (PDF) - Cirrus Logic

Número de pieza

componentes Descripción

Lista de partido

CS5510-ASZ
(Rev.:2009)

16-bit and 20-bit, 8-pin ΔΣ ADCs

Cirrus Logic 

CS5510/11/12/13

ground pin, CSLow defines the logic-low level for

the digital interface. Figures 9 and 10 illustrate the

threshold levels of the CS5510/11/12/13 serial in-

terface (CS, SCLK, and SDO).

To accommodate opto-isolators, the SCLK input is

designed with a Schmitt-trigger to allow an opto-

isolator with slower rise and fall times to directly

drive the pin. Additionally, SDO is capable of sink-

ing up to 1 mA or sourcing up to 5 mA to directly

drive an opto-isolator LED. SDO will have less than

a 600 mV loss in the drive voltage when sinking or

sourcing its current. As shown in Figure 11, the CS

signal provides the sink current path for the SDO

pin when its voltage is low (i.e. the voltage speci-

fied for SDO is relative to CSLow.).

2.4 Clock Generator

The CS5510/12 and CS5511/13 provide distinct

modes for generating the master clock for the

ADCs. The CS5510/12 uses the SCLK input pin as

its operating clock. The CS5511/13 has an on-chip

oscillator that provides its master clock. The SCLK

pin on the CS5511/13 is used only to read data and

to put the part into sleep mode.

V+

VIH == V+ - 0.45V

VIL = 0.5 (V+ - V-) + 0.6V + V-

CS LOW

V-

Figure 9. CS and SCLK Digital Input Levels.

2.4.1 External Clock Source for

CS5510/12

The user must provide an external (CMOS com-

patible) clock to the CS5510/12. The clock is input

to SCLK where it is then divided down to provide

the master clock for the ADC. The output word rate

(OWR) for the CS5510/12 is derived from the

SCLK, and is equal to SCLK/612. Figure 12 illus-

trates an external 32.768-kHz, CMOS-compatible

clock oscillator that a user might consider.

Another clock generation option is to use a micro-

controller. Some microcontrollers have dedicated

timer/counter circuitry which can generate a clock

signal on an output pin with no software overhead.

Such a microcontroller circuit is shown in

Figure 13.

Note that the CS5510 can operate with an exter-

nal, CMOS-compatible clock at frequencies up to

130 kHz, and the CS5512 can operate with an ex-

ternal clock of up to 200 kHz with a maximum

22 ns of jitter. Linearity performance is degraded

slightly with higher clock speeds, as shown in

Figures 14 and 15. The noise performance of the

parts, however, is not affected by higher clock

speeds.

2.4.2 Internal Oscillator for

CS5511/13

The CS5511/13 includes an on-chip oscillator. This

oscillator provides the master clock for the

V+

Output Drive Logic

5 mA Max Source

V+

VOH= V+ - 0.6V

VOL = CS LOW + 0.6V

VIL

CS LOW

V-

Figure 10. SDO Digital Output Levels.

SDO (from SDO

Control Logic)

1 mA Max Sink

CS (to CS

Control Logic)

Figure 11. Serial Port Output Drive Logic.

14

DS337F4

Share Link: