M29W010B90N6 Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Lista de partido

M29W010B90N6

1 Mbit (128Kb x8, Uniform Block) Low Voltage Single Supply Flash Memory

STMicroelectronics 

M29W010B

Figure 2. PLCC Connections

Figure 3. TSOP Connections

A7

A6

A5

A4

A3 9

A2

A1

A0

DQ0

1 32

M29W010B

17

A14

A13

A8

A9

25 A11

G

A10

E

DQ7

AI02748

A11

A9

A8

A13

A14

NC

W

VCC

NC

A16

A15

A12

A7

A6

A5

A4

1

32

8 M29W010B 25

9

24

16

17

AI02754

G

A10

E

DQ7

DQ6

DQ5

DQ4

DQ3

VSS

DQ2

DQ1

DQ0

A0

A1

A2

A3

Table 1. Signal Names

A0-A16

Address Inputs

DQ0-DQ7 Data Inputs/Outputs

E

Chip Enable

G

Output Enable

W

Write Enable

VCC

Supply Voltage

VSS

Ground

NC

Not Connected Internally

SUMMARY DESCRIPTION

The M29W010B is a 1 Mbit (128Kb x8) non-vola-

tile memory that can be read, erased and repro-

grammed. These operations can be performed

using a single low voltage (2.7 to 3.6V) supply. On

power-up the memory defaults to its Read mode

where it can be read in the same way as a ROM or

EPROM.

The memory is divided into blocks that can be

erased independently so it is possible to preserve

valid data while old data is erased. Each block can

be protected independently to prevent accidental

Program or Erase commands from modifying the

memory. Program and Erase commands are writ-

ten to the Command Interface of the memory. An

on-chip Program/Erase Controller simplifies the

process of programming or erasing the memory by

taking care of all of the special operations that are

required to update the memory contents. The end

of a program or erase operation can be detected

and any error conditions identified. The command

set required to control the memory is consistent

with JEDEC standards.

Chip Enable, Output Enable and Write Enable sig-

nals control the bus operation of the memory.

They allow simple connection to most micropro-

cessors, often without additional logic.

The memory is offered in PLCC32 or TSOP32 (8 x

20mm) packages and it is supplied with all the bits

erased (set to ’1’).

In order to meet environmental requirements, ST

offers the M29W010B in ECOPACK® packages.

ECOPACK packages are Lead-free. The category

of second Level Interconnect is marked on the

package and on the inner box label, in compliance

with JEDEC Standard JESD97. The maximum rat-

ings related to soldering conditions are also

marked on the inner box label.

ECOPACK is an ST trademark. ECOPACK speci-

fications are available at: www.st.com.

2/19

Share Link: