A25L016M-UF Ver la hoja de datos (PDF) - AMIC Technology

Número de pieza

componentes Descripción

Lista de partido

A25L016M-UF

(A25L010 - A25L512) Serial Flash Memory

AMIC Technology 

Sector Erase (SE)

The Sector Erase (SE) instruction sets to 1 (FFh) all bits

inside the chosen sector. Before it can be accepted, a Write

Enable (WREN) instruction must previously have been ex-

ecuted. After the Write Enable (WREN) instruction has been

decoded, the device sets the Write Enable Latch (WEL).

The Sector Erase (SE) instruction is entered by driving Chip

Select ( S ) Low, followed by the instruction code on Serial

Data Input (DIO). Chip Select ( S ) must be driven Low for the

entire duration of the sequence.

The instruction sequence is shown in Figure 13. Chip Select

( S ) must be driven High after the eighth bit of the instruction

code has been latched in, otherwise the Sector Erase

Figure 13. Sector Erase (SE) Instruction Sequence

A25L016 Series

instruction is not executed. As soon as Chip Select ( S ) is

driven High, the self-timed Sector Erase cycle (whose

duration is tSE) is initiated. While the Sector Erase cycle is in

progress, the Status Register may be read to check the value

of the Write In Progress (WIP) bit. The Write In Progress

(WIP) bit is 1 during the self-timed Sector Erase cycle, and is

0 when it is completed. At some unspecified time before the

cycle is completed, the Write Enable Latch (WEL) bit is reset.

A Sector Erase (SE) instruction applied to a page which is

protected by the Block Protect (TB, BP2, BP1, BP0) bits (see

table 1 and table 2) is not executed.

S

0 1 2 3 4 5 6 7 8 9 10 28 29 30 31

C

Instruction

24-Bit Address

DIO

23 22 21 3 2 1 0

MSB

Note:. Address bits A23 to A21 are Don’t Care, for A25L016.

(April, 2008, Version 0.0)

20

AMIC Technology Corp.

Share Link: