datasheetbank_Logo
búsqueda de Hoja de datos y gratuito Fichas de descarga

A29L004ATL-90F Ver la hoja de datos (PDF) - AMIC Technology

Número de pieza
componentes Descripción
Lista de partido
A29L004ATL-90F Datasheet PDF : 39 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Autoselect Mode
The autoselect mode provides manufacturer and device
identification, and sector protection verification, through
identifier codes output on I/O7 - I/O0. This mode is primarily
intended for programming equipment to automatically match
a device to be programmed with its corresponding
programming algorithm. However, the autoselect codes can
also be accessed in-system through the command register.
When using programming equipment, the autoselect mode
requires VID (11.5V to 12.5 V) on address pin A9. Address
pins A6, A1, and A0 must be as shown in Autoselect
Codes (High Voltage Method) table. In addition, when
verifying sector protection, the sector address must appear
A29L004A Series
on the appropriate highest order address bits. Refer to the
corresponding Sector Address Tables. The Command
Definitions table shows the remaining address bits that are
don't care. When all necessary bits have been set as
required, the programming equipment may then read the
corresponding identifier code on I/O7 - I/O0.To access the
autoselect codes in-system, the host system can issue the
autoselect command via the command register, as shown in
the Command Definitions table. This method does not
require VID. See "Command Definitions" for details on using
the autoselect mode.
Description
Manufacturer ID: AMIC
Device ID: A29L004A
(Top Boot Block)
Device ID: A29L004A
(Bottom Boot Block)
Continuation ID
Table 4. A29L004A Autoselect Codes (High Voltage Method)
CE OE WE A18 A12 A9 A8 A6 A5 A1
to to
to
to
A13 A10
A7
A2
L
L
H
X
X VID X
L
X
L
L
L
H
X
X
VID
X
L
X
L
L
L
H
X
X
VID
X
L
X
L
L
L
H
X
X VID X
L
X
H
Sector Protection Verification
L
L
H SA X VID X
L
X
H
L=Logic Low= VIL, H=Logic High=VIH, SA=Sector Address, X=Don’t Care.
Note: The autoselect codes may also be accessed in-system via command sequences.
A0
I/O7
to
I/O0
L
37h
H
34h
H
B5h
H
7Fh
01h
L
(protected)
00h
(unprotected)
PRELIMINARY (March, 2005, Version 0.0)
7
AMIC Technology, Corp.

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]