A4954 Ver la hoja de datos (PDF) - Allegro MicroSystems
Número de pieza
componentes Descripción
Lista de partido
A4954 Datasheet PDF : 9 Pages
| |||
A4954
Dual Full-Bridge DMOS
PWM Motor Driver
Application Information
Sense Pins (LSSx)
In order to use PWM current control, a low-value resistor is
placed between the LSSx pin and ground for current sensing pur-
poses. To minimize ground-trace IR drops in sensing the output
current level, the current sensing resistor should have an indepen-
dent ground return to the star ground point. This trace should be
as short as possible. For low-value sense resistors, the IR drops in
the PCB can be significant, and should be taken into account.
When selecting a value for the sense resistor be sure not to
exceed the maximum voltage on the LSSx pin of ±500 mV at
maximum load. During overcurrent events, this rating may be
exceeded for short durations.
Ground
A star ground should be located as close to the A4954 as possible.
The copper ground plane directly under the exposed thermal pad
of the device makes a good location for the star ground point. The
exposed pad can be connected to ground for this purpose.
Layout
The PCB should have a thick ground plane. For optimum
electrical and thermal performance, the A4954 must be soldered
directly onto the board. On the underside of the A4954 package is
an exposed pad, which provides a path for enhanced thermal dis-
sipation. The thermal pad must be soldered directly to an exposed
surface on the PCB in order to achieve optimal thermal conduc-
tion. Thermal vias are used to transfer heat to other layers of the
PCB.
The load supply pin, VBB, should be decoupled with an electro-
lytic capacitor (typically 100 μF) in parallel with a lower valued
ceramic capacitor placed as close as practicable to the device.
GND
RS12
C1
GND
RS34
C2
BULK
CAPACITANCE
GND
OUT4
OUT3
OUT2
OUT1
VBB
GND
1 GND
VREF34
IN3
IN4
IN2
IN1
VREF12
GND
A4954
PAD
VBB
OUT4
LSS34
OUT3
OUT2
LSS12
OUT1
VBB
RS34
RS12
C1
VBB
C2
Bill of Materials
Item
Reference
1
RS12, RS34
2
C1
3
C2
Value
0.25
(for VREF = 5 V, IOUT = 2 A)
0.22
100
Units
Ω
μF
μF
Description
2512, 1 W, 1% or better,
carbon film chip resistor
X5R minimum, 50 V or greater
Electrolytic, 50 V or greater
Allegro MicroSystems, Inc.
7
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
Share Link: 