AIC1523-0CS Ver la hoja de datos (PDF) - Analog Intergrations
Número de pieza
componentes Descripción
Lista de partido
AIC1523-0CS Datasheet PDF : 8 Pages
| |||
n PIN DESCRIPTION
PIN 1/4/6/8: NC:
PIN 2: CTL
- TTL compatible control input. It
controls the power switch turn-
on/turn-off. Active High for
AIC1523-1 and active low for
AIC1523-0.
AIC1523
PIN 3: IN-
PIN 4: GND-
PN 7: OUT-
Power supply input.
Chip power ground.
MOSFET switch output.
n APPLICATION INFORMATIONS
l Current Limit
l The current limit threshold is preset internally. It
protects the output MOSFET switches from
damage due to undesirable short circuit
conditions or excess inrush current often
encountered during hot plug-in. The AIC1523
allows minimum 500mA continuous load current
per Channel.
l Thermal Protection
When the chip temperature exceeds 110°C, the
thermal protection function works.
l Supply Filtering
A 0.1uF to 1uF bypass capacitor from IN to GND,
located near the device, is strongly recommended
to control supply transients. Without a bypass
capacitor, an output short may cause sufficient
ringing on the input (from supply lead inductance) to
damage internal control circuitry.
l Transient Droop Requirements
A current surge is caused by the input capacitance
of device. Ferrite beads are recommended in series
with all power and ground connector pins. Ferrite
beads reduce EMI and limit the inrush current
during hot-attachment by filtering high-frequency
signals.
l Short Circuit Transient
Bulk capacitance provides the short-term transient
current needed during a hot-attachment event. With
a 33uF, 16V tantalum or 100uF, 10V electrolytic
capacitor mounted close to downstream connector
should provide transient drop protection.
l Printed Circuit Layout
The power circuitry of printed circuit boards
requires a customized layout to maximize thermal
dissipation and to minimize voltage drop and EMI.
7
Share Link: 