AM79C982 Ver la hoja de datos (PDF) - Advanced Micro Devices

Número de pieza

componentes Descripción

Lista de partido

AM79C982

basic Integrated Multiport Repeater (bIMR)

Advanced Micro Devices 

PRELIMINARY

PIN DESCRIPTION

ACK

Acknowledge

Input, Active LOW

When this input is asserted, it signals to the requesting

bIMR device that it may control the DAT and JAM pins.

If the bIMR chip is not requesting control of the DAT line

(REQ pin HIGH), then the assertion of the ACK signal

indicates the presence of valid collision status on the

JAM or valid data on the DAT line.

AVDD

Analog Power

Power Pin

These pins supply +5 V to the RXD+/– receivers, the

DI+/– and CI+/– receivers, the DO+/– drivers, the inter-

nal PLL, and the internal voltage reference of the bIMR

device. These power pins should be decoupled and

kept separate from other power and ground planes.

AVSS

Analog Ground

Ground Pin

These pins are the 0 V reference for AVDD.

COL

Expansion Collision

Input, Active LOW

When this input is asserted by an external arbiter, it sig-

nifies that more than one bIMR device is active and that

each bIMR device should generate the Collision Jam

sequence independently.

CI+, CI–

Control In

Input

AUI port differential receiver. Signals comply with IEEE

802.3, Section 7.

CRS

Carrier Sense

Output

The states of the internal carrier sense signals for the

AUI port and the eight twisted-pair ports are serially

output on this pin continuously. The output serial bit

stream is synchronized to the X1 clock.

The resolution of the CRS signal is 2 ms. The incoming

data is sampled repeatedly during each 2-ms period. If

any activity occurs (regardless of length) during any

2-ms period, this activity will be latched. At the start of

the next 2-ms period the bIMR device will examine the

latches for each port. For any port for which activity

occurred, the corresponding bit in the CRS output

stream will remain set for the 2-ms period and will be

reset at the end of this period.

DAT

Data

Input/Output/3-State

In non-collision conditions, the active bIMR device will

drive DAT with NRZ data, including regenerated pre-

amble. During collision, when JAM = HIGH, DAT is

used to signal a multiport (DAT = 0) or single-port

(DAT = 1) condition.

When ACK is not asserted, DAT is in high impedance.

If REQ and ACK are both asserted, then DAT is an out-

put. If ACK is asserted and REQ not asserted, then

DAT is an input.

This pin needs to be either pulled up or pulled down

through a high-value resistor.

DI+, DI–

Data In

Input

AUI port differential receiver. Signals comply with IEEE

802.3, Section 7.

DO+, DO–

Data Out

Output

AUI port differential driver. Signals comply with IEEE

802.3, Section 7.

DVDD

Digital Power

Power Pin

These pins supply +5 V to the logic portions of the bIMR

chip and the TXP+/–, TXD+/–, and DO+/– line drivers.

DVSS

Digital Ground

Ground Pin

These pins are the 0 V reference for DVDD.

DVDD Pin #

19

DVSS Pin #

Function

16

TP ports 0 & 1 drivers

28

31

TP ports 2 & 3 drivers

43, 49

35, 37, 46, 51

Core logic and expansion

and control pins

59

56

TP ports 4 & 5 drivers

68

71

TP ports 6 & 7 drivers

Am79C982

1–9

Share Link: