CS5463-ISZ Ver la hoja de datos (PDF) - Cirrus Logic
Número de pieza
componentes Descripción
Lista de partido
CS5463-ISZ Datasheet PDF : 46 Pages
| |||
CS5463
SWITCHING CHARACTERISTICS (Continued)
Parameter
Symbol Min
Typ
Max Unit
E1, E2, and E3 Timing (Note 19 and 20)
Period
tperiod
250
-
-
µs
Pulse Width
tpw
244
-
-
µs
Rising Edge to Falling Edge
t3
6
-
-
µs
E2 Setup to E1 and/or E3 Falling Edge
t4
1.5
-
-
µs
E1 Falling Edge to E3 Falling Edge
t5
248
-
-
µs
Notes: 19. Pulse output timing is specified at MCLK = 4.096 MHz, E2MODE = 0, and E3MODE[1:0] = 0. Refer to
Section 5.5 Energy Pulse Output on page 17 for more information on pulse output pins.
20. Timing is proportional to the frequency of MCLK.
tpw
E1 t4
tperiod
t3
E2
t4
E3
t5
tpw
tperiod
t5
t3
Figure 2. Timing Diagram for E1, E2, and E3
ABSOLUTE MAXIMUM RATINGS
WARNING: Operation at or beyond these limits may result in permanent damage to the device.
Normal operation is not guaranteed at these extremes.
Parameter
DC Power Supplies
(Notes 21 and 22)
Positive Digital
Positive Analog
Input Current, Any Pin Except Supplies (Notes 23, 24, 25)
Output Current, Any Pin Except VREFOUT
Power Dissipation
(Note 26)
Analog Input Voltage
All Analog Pins
Digital Input Voltage
All Digital Pins
Ambient Operating Temperature
Storage Temperature
Symbol
VD+
VA+
IIN
IOUT
PD
VINA
VIND
TA
Tstg
Min
-0.3
-0.3
-
-
-
- 0.3
-0.3
-40
-65
Typ
Max
Unit
-
+6.0
V
-
+6.0
V
-
±10
mA
-
100
mA
-
500
mW
- (VA+) + 0.3 V
- (VD+) + 0.3 V
-
85
°C
-
150
°C
Notes: 21. VA+ and AGND must satisfy [(VA+) - (AGND)] ≤ + 6.0 V.
22. VD+ and AGND must satisfy [(VD+) - (AGND)] ≤ + 6.0 V.
23. Applies to all pins including continuous over-voltage conditions at the analog input pins.
24. Transient current of up to 100 mA will not cause SCR latch-up.
25. Maximum DC input current for a power supply pin is ±50 mA.
26. Total power dissipation, including all input currents and output currents.
DS678F2
13
Share Link: 