CXD2932AGA-2
Backup Mode
When the power supply of the GPS receiver system is off (XPWRS = low: the external pull-down is necessary)
and the reset state (XRS = low) is established, the device goes into the low power consumption state (backup
mode) where the all oscillators except for the timer stop. The whole internal memory status at this time is
retained and the Hot Start/Warm Start can be achieved. In order to cancel this mode, set the XRS pin to high
after XPWRS is set to high and then the oscillation stabilization time and the PLL lock-in time are waited.
(Normal operation / reset : VDD = 3.0 to 3.6V, backup mode : VDD = 2.0 to 3.6V)
OSC output
XPWRS
XRS
Normal
ED[31:0], EA[19:0]
PORT[15:0]
XCS[3:0], XWE[3:0],
XOE, XTCXO
TXD[1:0], CLKOUT
Backup
Reset
Normal
Oscillation stabilization time PLL lock-in time
(max. 1.0ms)
Pull-down output
Hi-Z output
High output
Low output
– 13 –