APR3011-15AC-TR Ver la hoja de datos (PDF) - Anpec Electronics

Número de pieza

componentes Descripción

Lista de partido

APR3011-15AC-TR

MicroPower Microprocessor Reset Circuit

Anpec Electronics 

APR3011/2/3

Application Information

VCC Transient Rejection

The APR3011/2/3 have the function to reject the tran-

sient glitches from the power line. The Maximum Tran-

sient Duration vs. Reset Threshold Overdrive shows

at Typical Characteristics.The transient voltage with

the duration under the curve will not generate a reset

signal, e.g. a transient of 100mV below the reset

threshold voltage have the duration more than 35us, it

will generate a reset signal. Connect a 0.1uF bypass

capacitor to the VCC pin can improve the transient

immunity.

VCC

VCC

RESET

GND

100K

Figure 1. Ensuring RESET Valid to VCC = 0 V

Reset Output

The APR3011/2/3 have 3 output stage versions:

APR3001 is an active low push-pull output, when the

VCC drops below the reset threshold, the RESET out-

put generates a low signal. APR3012 is an active high

push-pull output, when the VCC drops below the reset

threshold, the RESET output generates a high signal

(see Timing Chart). APR3013 is an active low open

drain output, the RESET output must be connected a

pull-up resistor to a supply voltage that is lower than

6V, it suits to use in multiple voltage systems (see

Figure 2). The APR3011 RESET output is valid until

the VCC=1.2V, below 1.2V the IC is shutdown, and

the output becomes a floating state. If it is a trouble, a

resistor should be connected from reset output to

ground to keep the reset output low (see Figure 1).

For The APR3012, a pull-up resistor to VCC is required

to keep the valid reset output for VCC below 1.2V.

+3.3V

+5.0V

VCC

APR3013

RESET

GND

VCC

100k

RESET 5V

INPUT System

GND

Figure 2. APR3013 Open Drain Output with Multiple

Supplies

Copyright  ANPEC Electronics Corp.

9

Rev. A.2 - Oct., 2003

www.anpec.com.tw

Share Link: