DS1677 Ver la hoja de datos (PDF) - Dallas Semiconductor -> Maxim Integrated
Número de pieza
componentes Descripción
Lista de partido
DS1677 Datasheet PDF : 18 Pages
| |||
DS1677
TIME OF DAY ALARM BITS Table 1
ALARM REGISTER MASK BITS (BIT 7)
SECONDS MINUTES HOURS DAYS
1
1
1
1
0
1
1
1
0
0
1
1
0
0
0
1
0
0
0
0
DESCRIPTION
Alarm once per second.
Alarm when seconds match.
Alarm when minutes and seconds match.
Alarm when hours, minutes and seconds match.
Alarm when day, hours, minutes and seconds match.
SPECIAL PURPOSE REGISTERS
The DS1677 has two additional registers (control register and status register) that control the RTC and
interrupts.
CONTROL REGISTER
BIT 7
BIT 6
BIT 5
EOSC
WP
AIS1
BIT 4
AIS0
BIT 3
0
BIT 2
0
BIT 1
0
BIT 0
AIE
EOSC (Enable Oscillator). This bit, when set to logic 0 will start the oscillator. When this bit is set to a
logic 1, the oscillator is stopped and the DS1677 is placed into a low-power standby mode with a current
drain of less than 200nA when in battery-backup mode. When the DS1677 is powered by VCC, the
oscillator is always on regardless of the status of the EOSC bit; however, the RTC is incremented only
when EOSC is a logic 0.
WP (Write Protect). Before any write operation to the real time clock or any other registers, this bit
must be logic 0. When high, the write protect bit prevents a write operation to any register.
AIS0–AIS1 (Analog Input Select). These two bits are used to determine the analog input for the analog-
to-digital conversion. Table 2 lists the specific analog input that is selected by these 2 bits.
AIE (Alarm Interrupt Enable). When set to a logic 1, this bit permits the Interrupt Request Flag (IRQF)
bit in the status register to assert INT. When the AIE bit is set to logic 0, the IRQF bit does not initiate the
INT signal.
ANALOG INPUT SELECTION Table 2
AIS1
AIS0
ANALOG INPUT
0
0
NONE
0
1
AIN0
1
0
AIN1
1
1
AIN2
6 of 18
Share Link: 