ELM622P Ver la hoja de datos (PDF) - Elm Electronics
Número de pieza
componentes Descripción
Lista de partido
ELM622P Datasheet PDF : 5 Pages
| |||
ELM622
Absolute Maximum Ratings
Storage Temperature....................... -65°C to +150°C
Ambient Temperature with
Power Applied....................................-40°C to +85°C
Voltage on VDD with respect to VSS............ 0 to +7.5V
Voltage on any other pin with
respect to VSS........................... -0.6V to (VDD + 0.6V)
Note:
Stresses beyond those listed here will likely damage
the device. These values are given as a design
guideline only. The ability to operate to these levels
is neither inferred nor recommended.
Electrical Characteristics
All values are for operation at 25°C and a 5V supply, unless otherwise noted. For further information, refer to note 1 below.
Characteristic
Minimum Typical Maximum Units
Conditions
Supply Voltage, VDD
4.5
5.0
5.5
V
VDD rate of rise
0.05
V/ms see note 2
Average Supply Current, IDD
1.0
2.4
mA see note 3
Input low voltage
VSS
0.15 VDD
V
Input high voltage
0.85 VDD
VDD
V
Output low voltage
0.6
V Current (sink) = 8.7mA
Output high voltage
Reset Output Pulse Width
Transmit Baud Rate
VDD - 0.7
90
9300
100
9600
110
9900
V Current (source) = 5.4mA
msec see note 4
baud see notes 4 and 5
Notes:
1. This integrated circuit is produced with a Microchip Technology Inc.’s PIC12C5XX as the core embedded
microcontroller. For further device specifications, and possibly clarification of those given, please refer to the
appropriate Microchip documentation.
2. This spec must be met in order to ensure that a correct power on reset occurs. It is quite easily achieved
using most common types of supplies, but may be violated if one uses a slowly varying supply voltage, as
may be obtained through direct connection to solar cells, or some charge pump circuits.
3. Device only. Does not include any LED or drive currents.
4. Pulse timing is internally generated, and affected by both temperature and supply voltage. Times shown are
the widest variation that can normally be expected.
5. Data is sent at this rate with eight data bits, no parity bit, and one stop bit. Process and temperature
variatons could typically result in as much as 3% error in this rate, but most UARTs would be tolerant of this.
In high reliability applications, one might use the fact that the eighth data bit is always ‘0’ to calibrate a timing
loop to the ELM622’s speed. The receiver could then compensate for variations in the data rate.
ELM622DSA
Elm Electronics – Circuits for the Hobbyist
< http://www.elmelectronics.com/ >
3 of 5
Share Link: 