datasheetbank_Logo
búsqueda de Hoja de datos y gratuito Fichas de descarga

FDC37C665IR Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza
componentes Descripción
Lista de partido
FDC37C665IR Datasheet PDF : 162 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
PIN NO.
NAME
38 Serial Port
Interrupt
Request
37 Serial Port
Interrupt
Request
40 Floppy
Controller
Interrupt
Request
39 Parallel Port
Interrupt
Request 1
DESCRIPTION OF PIN FUNCTIONS
BUFFER
SYMBOL TYPE
DESCRIPTION
IRQ4
O12 IRQ4 is the interrupt from the Primary Serial
Port (PSP) or Secondary Serial Port (SSP)
when the PSP or SSP have their address
programmed as COM1 or COM3 (as
defined in the Configuration Registers). The
appropriate interrupt from the Serial Port is
enabled/disabled via the Interrupt Enable
Register (IER). The interrupt is reset
inactive after interrupt service. It is disabled
through IER or hardware reset.
IRQ3
O12 IRQ3 is the interrupt from the Primary Serial
Port (PSP) or secondary Serial Port (SSP)
when the PSP or SSP have their address
programmed as COM2 or COM4 (as
defined in the Configuration Registers). The
appropriate interrupt from the Serial Port is
enabled/disabled via the Interrupt Enable
Register (IER). The interrupt is reset
inactive after interrupt service. It is disabled
through IER or hardware reset.
FINTR
O12 This interrupt from the Floppy Disk
Controller is enabled/disabled via bit 3 of the
Digital Output Register (DOR).
PINTR1
O12 This interrupt from the Parallel Port is
enabled/disabled via bit 4 of the Parallel
Port Control Register.
Refer to
configuration registers CR1 and CR3 for
more information.
OD12
If EPP or ECP Mode is enabled, this output
is pulsed low, then released to allow sharing
of interrupts.
57 Reset
RST
IS This active high signal resets the
FDC37C665IR and must be valid for 500 ns
minimum. The effect on the internal
registers is described in the appropriate
section. The configuration registers are not
affected by this reset.
FLOPPY DISK INTERFACE
16 nRead Disk Data nRDATA
IS Raw serial bit stream from the disk drive,
low active. Each falling edge represents a
flux transition of the encoded data.
6

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]