GP1A75 Ver la hoja de datos (PDF) - Sharp Electronics
Número de pieza
componentes Descripción
Lista de partido
GP1A75 Datasheet PDF : 4 Pages
| |||
GP1A75E
s Features
1. 3-pin connector terminal
2. High sensing accuracy
( Slit width: 0.5mm )
3. Wide gap between light emitter
and detector ( 5mm )
s Applications
1. Copiers
2. Laser beam printers
3. Facsimiles
GP1A75E
Small Size OPIC Photointerrupter
with Connector
s Outline Dimensions
(Unit : mm )
Internal connection diagram
(6.8)
Voltage regulator
φ 3.2
2.5
Amp.
1
2
15k Ω
3
24
JAPAN AMP made connector No.175487-3
Case surface
4.7
13.6
9.6
2.6
4.3 5 4.3 6.8 ± 1.0
2.35
2 - 0.5 ± 0.1
Slit width
18.1
2.4 1
32
0.3
0.9
+
-
0.2
0.15
1
2-R3.2
23
1 GND
2 VOUT
3 VCC
Chip resistor
* Unspecified tolerances
shall be as follows ;
Dimensions(d) Tolerance
d< 5.0 ± 0.15
5.0<=d< 15.0 ± 0.2
15.0<=d
± 0.3
* ( ) : Reference dimensions
*“OPIC” ( Optical IC ) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-
processing circuit integrated onto a single chip.
s Absolute Maximum Ratings (Ta= 25˚C )
Parameter
Supply voltage
*1 Low level output current
*2Operating temperature
*2 Storage temperature
Symbol Rating Unit
V CC - 0.5 to + 10 V
I OL
50
mA
Topr - 20 to + 75 ˚C
Tstg - 30 to + 85 ˚C
*1 Collector current of output transistor
*2 The connector should be plugged in/out and the unit's hook should be used at normal termperature.
“ In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in equipment using any of SHARP's devices, shown in catalogs,
data books, etc. Contact SHARP in order to obtain the latest version of the device specification sheets before using any SHARP's device.”
Share Link: 