HR30-10J-10P Ver la hoja de datos (PDF) - HIROSE ELECTRIC

Número de pieza

componentes Descripción

Lista de partido

HR30-10J-10P

Miniature Waterproof Plastic Connectors

HIROSE ELECTRIC 

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.

Cable

Push/pull

locking collar

A

Plug insulator body

Cable

Back shell

Guide keys

View A (2:1)

Cable

Tightening collar for back shell

Solder termination fixture

3

Groove - sealing bushing

Front edge of cable jacket

Figure B

Figure C

Connector

3 and 6 Pos.

10 and 12 Pos.

Back shell tightening collar size

16 mm

18 mm

Torque

0.5N.m

0.5N.m

1. To prevent accidental loosening of the back shell it is recommended that a small amount of primer (Loctite® 7649) and

adhesive (Loctite® 271) be applied to the threads of the insulator body before proceeding.

2. Keeping the terminated insulator body on the fixture, re-assembly the plug in order shown.

4. Using the correct back-tightening collar tighten the back shell to the specified torque.

When tightening the collar make sure that the cable will NOT turn.

5. Remove the assembly from the fixture.

Note: Loctite is a registered trademark of the Henkel Loctite Corporation.

11

Share Link: