IR2130 Ver la hoja de datos (PDF) - International Rectifier

Número de pieza

componentes Descripción

Lista de partido

IR2130

3-PHASE BRIDGE DRIVER

International Rectifier 

Data Sheet No. PD60019 Rev.P

IR2130/IR2132(J)(S) & (PbF)

3-PHASE BRIDGE DRIVER

Features

• Floating channel designed for bootstrap operation

Fully operational to +600V

Tolerant to negative transient voltage

dV/dt immune

• Gate drive supply range from 10 to 20V

• Undervoltage lockout for all channels

• Over-current shutdown turns off all six drivers

• Independent half-bridge drivers

• Matched propagation delay for all channels

• 2.5V logic compatible

• Outputs out of phase with inputs

• Cross-conduction prevention logic

• Also available LEAD-FREE

Description

Product Summary

VOFFSET

600V max.

IO+/-

200 mA / 420 mA

VOUT

10 - 20V

ton/off (typ.)

675 & 425 ns

Deadtime (typ.) 2.5 µs (IR2130)

0.8 µs (IR2132)

Packages

The IR2130/IR2132(J)(S) is a high voltage, high speed

power MOSFET and IGBT driver with three indepen-

dent high and low side referenced output channels. Pro-

prietary HVIC technology enables ruggedized

monolithic construction. Logic inputs are compatible with

28-Lead SOIC

CMOS or LSTTL outputs, down to 2.5V logic. A

ground-referenced operational amplifier provides

28-Lead PDIP

analog feedback of bridge current via an external cur-

rent sense resistor. A current trip function which termi-

nates all six outputs is also derived from this resistor.

44-Lead PLCC w/o 12 Leads

An open drain FAULT signal indicates if an over-cur-

rent or undervoltage shutdown has occurred. The output drivers feature a high pulse current buffer stage designed

for minimum driver cross-conduction. Propagation delays are matched to simplify use at high frequencies. The

floating channels can be used to drive N-channel power MOSFETs or IGBTs in the high side configuration

which operate up to 600 volts.

Typical Connection

(Refer to Lead Assignments for correct pin configuration). This/These diagram(s) show electrical connections only. Please refer

to our Application Notes and DesignTips for proper circuit board layout.

www.irf.com

1

Share Link: