datasheetbank_Logo
búsqueda de Hoja de datos y gratuito Fichas de descarga

IR3088A(2004) Ver la hoja de datos (PDF) - International Rectifier

Número de pieza
componentes Descripción
Lista de partido
IR3088A
(Rev.:2004)
IR
International Rectifier IR
IR3088A Datasheet PDF : 34 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
IR3088A
SYSTEM THEORY OF OPERATION
XPhaseTM Architecture
The XPhaseTM architecture is designed for multiphase interleaved buck converters which are used in applications
requiring small size, design flexibility, low voltage, high current and fast transient response. The architecture can
control converters of any phase number where flexibility facilitates the design trade-off of multiphase converters. The
scalable architecture can be applied to other applications which require high current or multiple output voltages.
As shown in Figure 1, the XPhaseTM architecture consists of a Control IC and a scalable array of phase converters
each using a single Phase IC. The Control IC communicates with the Phase ICs through a 5-wire analog bus, i.e.
bias voltage, phase timing, average current, error amplifier output, and VID voltage. The Control IC incorporates all
the system functions, i.e. VID, PWM ramp oscillator, error amplifier, bias voltage, and fault protections etc. The
Phase IC implements the functions required by the converter of each phase, i.e. the gate drivers, PWM comparator
and latch, over-voltage protection, and current sensing and sharing.
There is no unused or redundant silicon with the XPhaseTM architecture compared to others such as a 4 phase
controller that can be configured for 2, 3, or 4 phase operation. PCB Layout is easier since the 5 wire bus eliminates
the need for point-to-point wiring between the Control IC and each Phase. The critical gate drive and current sense
connections are short and local to the Phase ICs. This improves the PCB layout by lowering the parasitic inductance
of the gate drive circuits and reducing the noise of the current sense signal.
POWER GOOD
PHASE FAULT
VR HOT
12V
ENABLE
VID5
VID0
VID1
VID2
VID3
VID4
IR3081
CONTROL
IC
>> BIAS VOLTAGE
>> PHASE TIMING
<< CURRENT SENSE
>> PWM CONTROL
>> VID VOLTAGE
PHASE FAULT
CURRENT SHARE
IR3088A
PHASE IC
PHASE HOT
0.1uF
CCS RCS
CIN
COUT
VOUT SENSE+
VOUT+
VOUT-
VOUT SENSE-
PHASE FAULT
CURRENT SHARE
IR3088 A
PHASE IC
PHASE HOT
0.1uF
CCS RCS
Page 6 of 34
CONTROL BUS
ADDITIONAL PHASES
INPUT/OUTPUT
Figure 1. System Block Diagram
9/30/04

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]