LAN83C183 Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

Lista de partido

LAN83C183

10/100 Mbps TX/FX/10BT Fast Ethernet Physical Layer Device (PHY)

SMSC -> Microchip 

MLT3 encoded output data from the comparators and converts it to normal digital

data to be used for clock and data recovery.

1.2.8.2 10 MBITS/S TP RECEIVER

The 10 Mbits/s receiver detects input signals from the twisted-pair cable that are

within the template shown in Figure 1.5 The TP inputs are biased by internal resistors

and go through a low-pass filter designed to eliminate any high-frequency input

noise. The output of the receive filter goes to two different types of comparators:

squelch and zero crossing. The squelch comparator determines whether the signal

is valid, and the zero crossing comparator senses the actual data transitions after the

signal is determined to be valid. The output of the squelch comparator goes to the

squelch circuit and is also used for link pulse detection, SOI detection, and reverse

polarity detection. The output of the zero-crossing comparator is used for clock and

data recovery in the Manchester decoder.

Figure 1.5 TP Input Voltage Template (10 Mbits/s)

Short Bit

3.1 V

Slope 0.5 V/ns

585 mV

585 mV sin (π ∗ t/PW)

0

PW

Long Bit

3.1 V

Slope 0.5 V/ns

585 mV sin (π ∗ t/PW)

585 mV sin[2 π (t − PW2)/PW)]

0 PW/4

3PW/4 PW

585 mV

1.2.8.3 SQUELCH (100 MBITS/S)

The Squelch block determines if the TP input contains valid data. The 100 Mbits/s

TP squelch is one of the criteria used to determine link integrity. The squelch

comparators compare the TP inputs against fixed positive and negative thresholds,

called squelch levels. The output from the squelch comparator goes to a digital

squelch circuit, which determines whether the receive input data on that port is valid.

If the data is invalid, the receiver is in the squelched state. If the input voltage

exceeds the squelch levels at least four times with alternating polarity within a 10 µs

interval, the squelch circuit determines that the data is valid and the receiver enters

into the unsquelch state.

In the unsquelch state, the receive threshold level is reduced by approximately 30%

for noise immunity reasons and is called the unsquelch level. When the receiver is

in the unsquelch state, the input signal is considered valid.

SMSC DS – LAN83C183

28

Rev. 12/14/2000

Share Link: