LPC47M107S-MC Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

Lista de partido

LPC47M107S-MC

100 Pin Enhanced Super I/O Controller with LPC Interface for Consumer Applications

SMSC -> Microchip 

LPC TRANSFER SEQUENCE EXAMPLES

Wait State Requirements

I/O Transfers

The LPC47M10x inserts three wait states for an I/O read and two wait states for an I/O write cycle. A SYNC of 0110

is used for all I/O transfers. The exception to this is for transfers where IOCHRDY has been deasserted (i.e., EPP or

IrCC transfers) in which case the sync pattern of 0110 is used and a large number of syncs may be inserted (up to

330 which corresponds to a timeout of 10us).

DMA Transfers

The LPC47M10x inserts three wait states for a DMA read and four wait states for a DMA write cycle. A SYNC of

0101 is used for all DMA transfers.

See the example timing for the LPC cycles in the “Timing Diagrams” section.

FLOPPY DISK CONTROLLER

The Floppy Disk Controller (FDC) provides the interface between a host microprocessor and the floppy disk drives. The

FDC integrates the functions of the Formatter/Controller, Digital Data Separator, Write Precompensation and Data Rate

Selection logic for an IBM XT/AT compatible FDC. The true CMOS 765B core guarantees 100% IBM PC XT/AT

compatibility in addition to providing data overflow and underflow protection.

The FDC is compatible to the 82077AA using

SMSC's proprietary floppy disk controller core.

FDC INTERNAL REGISTERS

The Floppy Disk Controller contains eight internal registers which facilitate the interfacing between the host

microprocessor and the disk drive. Table 2 shows the addresses required to access these registers. Registers other

than the ones shown are not supported. The rest of the description assumes that the primary addresses have been

selected.

PRIMARY

ADDRESS

3F0

3F1

3F2

3F3

3F4

3F4

3F5

3F6

3F7

3F7

Table 2 - Status, Data and Control Registers

(Shown with base addresses of 3F0 and 370)

SECONDARY

ADDRESS

R/W

REGISTER

370

R

Status Register A (SRA)

371

R

Status Register B (SRB)

372

R/W Digital Output Register (DOR)

373

R/W Tape Drive Register (TSR)

374

R

Main Status Register (MSR)

374

W Data Rate Select Register (DSR)

375

R/W Data (FIFO)

376

Reserved

377

R

Digital Input Register (DIR)

377

W Configuration Control Register (CCR)

STATUS REGISTER A (SRA)

Address 3F0 READ ONLY

This register is read-only and monitors the state of the internal interrupt signal and several disk interface pins in PS/2

and Model 30 modes. The SRA can be accessed at any time when in PS/2 mode. In the PC/AT mode the data bus pins

D0 - D7 are held in a high impedance state for a read of address 3F0.

PS/2 Mode

Page 21

Share Link: