LPC47M144-NC Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

Lista de partido

LPC47M144-NC

128 Pin Enhanced Super I/O Controller with an LPC Interface and USB Hub

SMSC -> Microchip 

6.3 LPC INTERFACE

The following sub-sections specify the implementation of the LPC bus.

6.3.1 LPC Interface Signal Definition

The signals required for the LPC bus interface are described in the table below. LPC bus signals use PCI 33MHz

electrical signal characteristics.

SIGNAL

NAME

LAD[3:0]

LFRAME#

PCI_RESET#

LDRQ#

nIO_PME

LPCPD#

SER_IRQ

PCI_CLK

TYPE

I/O

Input

Input

Output

OD

Input

I/O

Input

DESCRIPTION

LPC address/data bus. Multiplexed command, address and data bus.

Frame signal. Indicates start of new cycle and termination of broken cycle

PCI Reset. Used as LPC Interface Reset.

Encoded DMA/Bus Master request for the LPC interface.

Power Mgt Event signal. Allows the LPC47M14x to request wakeup.

Powerdown Signal. Indicates that the LPC47M14x should prepare for power to be shut

on the LPC interface.

Serial IRQ.

PCI Clock.

Note: The CLKRUN# signal is not implemented in this part.

6.3.2 LPC Cycles

The following cycle types are supported by the LPC protocol.

CYCLE TYPE

I/O Write

I/O Read

DMA Write

DMA Read

TRANSFER SIZE

1 Byte

1 Byte

1 byte

1 byte

The LPC47M14x ignores cycles that it does not support.

6.3.3 Field Definitions

The data transfers are based on specific fields that are used in various combinations, depending on the cycle type.

These fields are driven onto the LAD[3:0] signal lines to communicate address, control and data information over the

LPC bus between the host and the LPC47M14x. See the “Low Pin Count (LPC) Interface Specification”, Revision

1.0, Section 4.2 for definition of these fields.

6.3.4 LFRAME# Usage

LFRAME# is used by the host to indicate the start of cycles and the termination of cycles due to an abort or time-out

condition. This signal is to be used by the LPC47M14x to know when to monitor the bus for a cycle.

This signal is used as a general notification that the LAD[3:0] lines contain information relative to the start or stop of a

cycle, and that the LPC47M14x monitors the bus to determine whether the cycle is intended for it. The use of

LFRAME# allows the LPC47M14x to enter a lower power state internally. There is no need for the LPC47M14x to

monitor the bus when it is inactive, so it can decouple its state machines from the bus, and internally gate its clocks.

When the LPC47M14x samples LFRAME# active, it immediately stops driving the LAD[3:0] signal lines on the next

clock and monitor the bus for new cycle information.

The LFRAME# signal functions as described in the Low Pin Count (LPC) Interface Specification, Revision 1.0.

SMSC DS – LPC47M14X

Page 21

Rev. 03/19/2001

Share Link: