LT1330 Ver la hoja de datos (PDF) - Linear Technology

Número de pieza

componentes Descripción

Lista de partido

LT1330

5V RS232 Transceiver with 3V Logic Interface and One Receiver Active in Shutdown

Linear Technology 

TYPICAL PERFOR A CE CHARACTERISTICS

LT1330

Driver Short-Circuit Current

30

25

ISC+

20

15

ISC–

10

5

0

–55 –25

0 25 50 75

TEMPERATURE (°C)

100 125

1330 G10

Receiver Output Waveforms

RX5 OUTPUT

CL = 50pF

RX1 TO RX4

OUTPUT

CL = 50pF

INPUT

VL = 3V

1330 G12

Receiver Short-Circuit Current

40

35

RX1 TO RX4

30

ISC+

25

RX1 TO RX4

ISC –

20

15

RX5 ISC+

10

5

RX5 ISC–

0

–55 –25

0 25 50 75

TEMPERATURE (°C)

100 125

1330 G11

Driver Output Waveforms

DRIVER OUTPUT

RL = 3k

CL = 2500pF

DRIVER OUTPUT

RL = 3k

INPUT

1330 G13

PI FU CTIO S

VCC: 5V Input Supply Pin. This pin should be decoupled

with a 0.1µF ceramic capacitor close to the package pin.

Insufficient supply bypassing can result in low output

drive levels and erratic charge pump operation.

VL: 3V Logic Supply Pin for all RS232 Receivers. Like VCC,

the VL input should be decoupled with a 0.1µF ceramic

capacitor. This pin may also be connected to 5V.

GND: Ground Pin.

ON/OFF: TTL/CMOS Compatible Operating Mode Control.

A logic low puts the device in the low power shutdown

mode. All three drivers and four receivers (RX1, RX2, RX3,

and RX4) assume a high impedance output state in shut-

down. Only receiver RX5 remains active while the trans-

ceiver is in shutdown. The transceiver consumes only

60µA of supply current while in shutdown. A logic high

fully enables the transceiver.

DRIVER DISABLE: This pin provides an alternate control

for the charge pump and RS232 drivers. A logic high on

this pin shuts down the charge pump and places all driver

outputs in a high impedance state. All five receivers remain

active under these conditions. Floating the driver disable

pin or driving it to a logic low level fully enables the

transceiver. A logic low on the ON/OFF pin supersedes the

state of the DRIVER DISABLE pin. Supply current drops to

3mA when in driver disable mode.

V+: Positive Supply Output. V+ ≈ 2VCC – 1.5V. This pin

requires an external charge storage capacitor, C ≥ 1.0µF,

tied to ground or 5V. Larger value capacitors may be used

5

Share Link: