LTC2202I(RevB) Ver la hoja de datos (PDF) - Linear Technology

Número de pieza

componentes Descripción

Lista de partido

LTC2202I
(Rev.:RevB)

16-Bit, 25Msps/10Msps ADCs

Linear Technology 

LTC2203/LTC2202

APPLICATIO S I FOR ATIO

Figure 5 demonstrates the use of an LTC1994 differential The internal programmable gain amplifier provides the

amplifier to convert a single ended input signal into a internal reference voltage for the ADC. This amplifier has

differential input signal. The advantage of this method is very stringent settling requirements and is not accessible

that it provides low frequency input response; however, for external use.

the limited gain bandwidth of any op amp will limit the

SFDR at high input frequencies.

LTC2203/02

RANGE

SELECT

2.2 μF

499Ω

100pF

VCM

LTC2203/02

TIE TO VDD TO USE

INTERNAL 2.5V

REFERENCE

OR INPUT FOR

SENSE

AND GAIN

CONTROL

INTERNAL

ADC

REFERENCE

S

523Ω

–+

AIN+

EXTERNAL 2.5V

REFERENCE

OR INPUT FOR

PGA

CM LT1994

100pF

EXTERNAL 1.25V

499Ω

+–

AIN–

REFERENCE

2.5V

BANDGAP

53.6Ω

100pF

REFERENCE

499Ω

22032 F05

Figure 5. DC Coupled Input with Differential Amplifier

VCM

2.2μF

BUFFER

1.25V

The 25Ω resistors and 12pF capacitor on the analog

inputs serve two purposes: isolating the drive circuitry

from the sample-and-hold charging glitches and limiting

the wideband noise at the converter input.

Reference Operation

Figure 6 shows the LTC2203/LTC2202 reference circuitry

consisting of a 2.5V bandgap reference, a programmable

gain amplifier and control circuit. The LTC2203/LTC2202

has three modes of reference operation: Internal Refer-

ence, 1.25V external reference or 2.5V external reference.

To use the internal reference, tie the SENSE pin to VDD. To

use the external reference, simply apply either a 1.25V or

2.5V reference voltage to the SENSE input pin. Both 1.25V

and 2.5V applied to SENSE will result in a full scale range

of 2.5VP-P (PGA = 0). A 1.25V output, VCM, is provided

for a common mode bias for input drive circuitry. An

external bypass capacitor is required for the VCM output.

This provides a high frequency low impedance path to

ground for internal and external circuitry. This is also the

compensation capacitor for the reference; it will not be

stable without this capacitor. The minimum value required

for stability is 2.2µF.

22032 F07

Figure 6. Reference Circuit

The SENSE pin can be driven ±5% around the nominal 2.5V

or 1.25V external reference input. This adjustment range

can be used to trim the ADC gain error or other system

gain errors. When selecting the internal reference, the

SENSE pin should be tied to VDD as close to the converter

as possible. If the sense pin is driven externally it should

be bypassed to ground as close to the device as possible

with at least a 1µF ceramic capacitor.

3.3V

1μF

1.25V

2

6

LT1461-2.5

4

VCM

2.2μF

SENSE LTC2203/02

2.2μF

22032 F08

Figure 7. A 2.25V Range ADC with

an External 2.5V Reference

22032fb

21

Share Link: