MSM7580 Ver la hoja de datos (PDF) - Oki Electric Industry
Número de pieza
componentes Descripción
Lista de partido
MSM7580 Datasheet PDF : 18 Pages
| |||
¡ Semiconductor
MSM7580
SYNCA1 , SYNCA2
Synchronous signal input pins.
SYNCA1 and SYNCA 2 control the ADPCM data input/output timing for Channel 1 (SIA1,
SOA1) and Channel 2 (SIA2, SOA2), respectivery.
The ADPCM data can be input or output with timing other than the PCM data interface.
Therefore PCM and ADPCM interfaces can be used at a mutually independent timing except
some timing.
Since master clocks are generated by the internal PLL using SYNCA, a synchronous signal
should be input to there pins.
Note: When PCM and ADPCM data interfaces are used at a mutually independent timing, the
timing described in "Notes on Usage" should not be used.
DET1, DET2
Special ADPCM input data pattern detect pins.
When a 4-bit continuous "0" pattern at the ADPCM input pins Channel 1 (STA1) and Channel 2
(SIA2) is detected, DET1 and DET2 go from a digital "0" to a digital "1" state.
A digital "1" is output at the rising edge of the clock.
The fourth data bit (LSB) is clocked into the register by the bit clock (BCLKA) and the held there
until the rising edge in the next time frame.
When detecting the special data pattern in the next time frame, the digital "1" on the pins DET
(1, 2) is remains. When the THR1 pin or THR2 pin is at digital "1" level, the functions of these pins
are invalid.
RES1, RES2
Algorithm reset signal input pins for Channel 1 (RES1) and Channel 2 (RES2).
When a digital “0” is applied, the entire transcoder goes to its initial state.
This reset is defined by ITU-T G.721 and is an optional reset.
BCLKA
Bit clock input pin used to define the data transmission speed at the ADPCM interface.
This pin can be used for Channels 1 and 2, which allows the ADPCM data interface speed to be
defined differently than the PCM data interface speed.
VDD
Power supply.
The device must operate at +5 V ±10%.
6/17
Share Link: 