NCV8660 Ver la hoja de datos (PDF) - ON Semiconductor
Número de pieza
componentes Descripción
Lista de partido
NCV8660 Datasheet PDF : 14 Pages
| |||
NCV8660
IN
OUT
Reset Delay Time
RO
t < Reset Reaction Time
t
OUT Reset Threshold plus Hysteresis
OUT Reset Threshold
t
Reset
Threshold
Plus
Hysteresis
Thermal
Shutdown
Voltage Dip
at Input
Reset Delay Time
Secondary Overload
Spike at Output
Thermal Shutdown
minus
Thermal Hysteresis
Figure 25. Reset Timing
Reset
Reaction
Time
t
Reset Delay Time
During power−up (or restoring OUT voltage from a reset
event), the OUT voltage must be maintained above the Reset
threshold for the Reset Delay time before RO goes high. The
time for Reset Delay is determined by the choice of IC and
the state of the DT pin.
Reset Delay Time Select
Selection of the NCV8660 device and the state of the DT
pin determines the available Reset Delay times. The part is
designed for use with DT tied to ground or OUT, but may be
controlled by any logic signal which provides a threshold
between 0.8 V and 2 V. The default condition for an open DT
pin is the slower Reset time (DT = GND condition). Times
are in pairs and are highlighted in the chart below. Consult
factory for availability.
NCV86601
NCV86602
NCV86603
NCV86604
DT=GND
Reset Time
8 ms
8 ms
16 ms
32 ms
DT=OUT
Reset Time
128 ms
32 ms
64 ms
128 ms
The Delay Time select (DT) pin is logic level controlled
and provides Reset Delay time per the chart. Note the DT pin
is sampled only when RO is low, and changes to the DT pin
when RO is high will not effect the reset delay time.
Thermal Shutdown
When the die temperature exceeds the Thermal Shutdown
threshold, a Thermal Shutdown event is detected OUT is
turned off, and RO goes low. The IC will remain in this state
until the die temperature moves below the shutdown
threshold (175°C typical) minus the hysteresis factor (25°C
typical). The output will then turn back on and RO will go
high after the RESET Delay time.
http://onsemi.com
10
Share Link: 