NJM2827 Ver la hoja de datos (PDF) - Japan Radio Corporation

Número de pieza

componentes Descripción

Lista de partido

NJM2827

Negative Output Low Drop Out voltage regulator

Japan Radio Corporation  

NJM2827

„ TYPICAL APPLICATIONS

0.1µF

VIN

1.0µF*4

(Ceramic)

GND

VIN

VOUT

NJM2827

CS

VOUT

Cs=0.047µF

CS

*4 -2.2V≤Vo≤-2.0V version: Co=2.2µF(Ceramic)

Vo>-2.0V version: Co=4.7µ F(Ceramic)

¿Input Capacitance CIN

Input capacitance CIN is required to prevent oscillation and reduce power supply ripple for applications with high

power supply impedance or a long power supply line.

Use the CIN value of 0.1µF greater to avoid the problem.

CIN should connect between GND and VIN as short as possible.

¿Output Capacitance CO

Output capacitor (Co) is required for a phase compensation of the internal error amplifier. The capacitance and the

equivalent series resistance (ESR) influences stability of the regulator.

This product is designed to work with a low ESR capacitor for the Co; however, use of recommended capacitance or

greater value is essential for stable operation.

Use of a smaller Co may cause excess output noise or oscillation of the regulator due to lack of the phase

compensation.

Therefore, use Co with the recommended capacitance or greater value and connect between Vo terminal and GND

terminal with minimal wiring. The recommended capacitance depends on the output voltage. Low voltage regulator

requires greater value of the Co. Thus, check the recommended capacitance for each output voltage.

Use of a greater Co reduces output noise and ripple output, and also improves transient response of the output

voltage against rapid load change.

-4-

Ver.2010-07-13

Share Link: