PE42556DI(2010) Ver la hoja de datos (PDF) - Peregrine Semiconductor Corp.
Número de pieza
componentes Descripción
fabricante
PE42556DI Datasheet PDF : 10 Pages
| |||
PE42556
Product Specification
Evaluation Kit
The SPDT switch EK Board was designed to ease
customer evaluation of Peregrine's PE42556 (dual
use with PE42554). The RF Common port is
connected through a 50ohm transmission line via
the top SMA connector, J1. RF1 and RF2 are
connected through 50ohm transmission lines via
SMA connectors J3, and J2, respectively. A
through 50ohm transmission line is available via
SMA connectors J4 and J5. This transmission
line can be used to estimate the loss of the PCB
over the environmental conditions being
evaluated.
The board is constructed of a four metal layers
with a total thickness of 62 mils. The top and
bottom layers are ROGERS RO4003 material with
an 8 mil core and Er=3.55. The middle layers
provide ground for the transmission lines. The RF
transmission lines were designed using a coplanar
waveguide with ground plane model using a trace
width of 15 mils, and trace gaps of 10 mils.
General Comments
--
Transmission lines connected to J1, J2, and J3 should
have exactly the same electrical length.
The path from J2 to J3 including the distance through the part
should have the same length as J4 and J5 and be in parallel to
J4 to J5.
NOTES:
1. USE 101-0402-02 PCB
Figure 6. Evaluation Board Layouts
Peregrine Specification 101/0402
X
Figure 7. Evaluation Board Schematic
Peregrine Specification 102/0478
J9
HEADER, 12 PIN
1 CTL
3 LS
5 NC
7 VDD
9 VSS
11 GND
GND 2
GND 4
GND 6
GND 8
GND 10
GND 12
J1
2
1
6 RFC
U1
PE42554
RF1 8
RF2 4
2
J3
1
2
J2
1
J4
2
1
Document No. 70-0289-05 │ www.psemi.com
2
J5
1
©2009-2010 Peregrine Semiconductor Corp. All rights reserved.
Page 5 of 10
Share Link: 