PI5V331QE Ver la hoja de datos (PDF) - Pericom Semiconductor
Número de pieza
componentes Descripción
Lista de partido
PI5V331QE Datasheet PDF : 7 Pages
| |||
PI5V331
Low On-Resistance Wideband Video
Dual 4-Channel Mux/DeMux
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ............................................................ –65°C to +150°C
Note:
Stresses greater than those listed under MAXIMUM RAT-
Ambient Temperature with Power Applied ........................... –40°C to +85°C INGS may cause permanent damage to the device. This is
Supply Voltage to Ground Potential (Inputs & VCC Only)..... –0.5V to +7.0V
a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
Supply Voltage to Ground Potential (Outputs & D/O Only) .. –0.5V to +7.0V operational sections of this specification is not implied. Ex-
DC Input Voltage ....................................................................–0.5V to +7.0V
posure to absolute maximum rating conditions for extended
periods may affect reliability.
DC Output Current.............................................................................. 120 mA
Power Dissipation ................................................................................... 0.5W
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ±5%)
Parameters
Description
Test Conditions(1)
Min.
Typ(2)
VANALOG Analog Signal Range
0
—
VIH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
—
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
—
IIH
Input HIGH Current
VCC = Max., VIN = VCC
—
—
IIL
Input LOW Current
VCC = Max., VIN = GND
—
—
IO
Analog Output Leakage
Current
0 ≤ S1, S2 or D ≤VCC,
Switch Off
—
—
VIK
Clamp Diode Voltage
VCC = Min., IIN = –18 mA
—
–0.7
IOS
Short Circuit Current(3)
S1, S2, D = 0V VCC
100
—
VH
Input Hysteresis at Control
Pins
—
150
Max.
2.0
—
0.8
±1
±1
±1
–1.2
—
—
Units
V
µA
V
mA
mV
RON
Switch On-Resistance(4)
VCC = Min., VOUT = 0.975V,
RL = 75Ω, ION = 13 mA
—
3
7
Ω
VCC = MIN., VOUT = 1.95V,
RL = 75Ω, ION = 26 mA
—
7
10
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 5.0V, TA = 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between S1, S2, and D I/O pins at indicated current through the switch. On-Resistance is determined by the
lower of the voltages on the S1, S2, and D I/O pins. VOUT is the voltage across RL.
2
PS8117B
09/13/04
Share Link: 