SAA7108AE Ver la hoja de datos (PDF) - Philips Electronics

Número de pieza

componentes Descripción

Lista de partido

SAA7108AE

HD-CODEC

Philips Electronics 

Philips Semiconductors

HD-CODEC

Product specification

SAA7108AE; SAA7109AE

21.5 Suitability of surface mount IC packages for wave and reflow soldering methods

PACKAGE(1)

BGA, HTSSON..T(3), LBGA, LFBGA, SQFP, SSOP..T(3), TFBGA,

USON, VFBGA

DHVQFN, HBCC, HBGA, HLQFP, HSO, HSOP, HSQFP, HSSON,

HTQFP, HTSSOP, HVQFN, HVSON, SMS

PLCC(5), SO, SOJ

LQFP, QFP, TQFP

SSOP, TSSOP, VSO, VSSOP

CWQCCN..L(8), PMFP(9), WQCCN..L(8)

SOLDERING METHOD

WAVE

REFLOW(2)

not suitable

suitable

not suitable(4)

suitable

suitable

suitable

not recommended(5)(6) suitable

not recommended(7) suitable

not suitable

not suitable

Notes

1. For more detailed information on the BGA packages refer to the “(LF)BGA Application Note” (AN01026); order a copy

from your Philips Semiconductors sales office.

2. All surface mount (SMD) packages are moisture sensitive. Depending upon the moisture content, the maximum

temperature (with respect to time) and body size of the package, there is a risk that internal or external package

cracks may occur due to vaporization of the moisture in them (the so called popcorn effect). For details, refer to the

Drypack information in the “Data Handbook IC26; Integrated Circuit Packages; Section: Packing Methods”.

3. These transparent plastic packages are extremely sensitive to reflow soldering conditions and must on no account

be processed through more than one soldering cycle or subjected to infrared reflow soldering with peak temperature

exceeding 217 °C ± 10 °C measured in the atmosphere of the reflow oven. The package body peak temperature

must be kept as low as possible.

4. These packages are not suitable for wave soldering. On versions with the heatsink on the bottom side, the solder

cannot penetrate between the printed-circuit board and the heatsink. On versions with the heatsink on the top side,

the solder might be deposited on the heatsink surface.

5. If wave soldering is considered, then the package must be placed at a 45° angle to the solder wave direction.

The package footprint must incorporate solder thieves downstream and at the side corners.

6. Wave soldering is suitable for LQFP, TQFP and QFP packages with a pitch (e) larger than 0.8 mm; it is definitely not

suitable for packages with a pitch (e) equal to or smaller than 0.65 mm.

7. Wave soldering is suitable for SSOP, TSSOP, VSO and VSSOP packages with a pitch (e) equal to or larger than

0.65 mm; it is definitely not suitable for packages with a pitch (e) equal to or smaller than 0.5 mm.

8. Image sensor packages in principle should not be soldered. They are mounted in sockets or delivered pre-mounted

on flex foil. However, the image sensor package can be mounted by the client on a flex foil by using a hot bar

soldering process. The appropriate soldering profile can be provided on request.

9. Hot bar or manual soldering is suitable for PMFP packages.

2004 Jun 29

194

Share Link: