CD1283 Ver la hoja de datos (PDF) - Intel

Número de pieza

componentes Descripción

Lista de partido

CD1283

IEEE 1284-Compatible Parallel Interface

Intel 

CD1283 — IEEE 1284-Compatible Parallel Interface

Symbol

Pin No.

Type

Description (Sheet 3 of 3)

NOTE: The above five parallel handshake signals are driven by the slave in an IEEE Std 1284 interface, and as such are

outputs from the CD1283. Their functions depend on the transfer protocol selected. Refer to the IEEE Std 1284-1994

document for protocol functions. (See Section 5.4.1 on page 33 for ordering information.)

EBDIR

EXTERNAL BUFFER DIRECTION: This signal is controlled by the internal parallel

port control state machine and can be used to control the direction of an external buffer

connected to the Parallel Port data bus. An external buffer might be desirable in

49

O

applications that require higher drive capacity than that provided by the CD1283.

EBDIR can be used in conjunction with PDBEN to control this buffer. EBDIR is a logic

‘0’ when the parallel data bus is in an output mode, and a logic ‘1’ when in an input

mode. It can be connected directly to the direction control input of a 74245-type device.

PDBEN

PARALLEL DATA BUS ENABLE: This signal can control a buffer on the Parallel Port

data lines in applications requiring more signal-drive capability than provided by the

CD1283. PDBEN is controlled by the internal Parallel Port control state machine.

51

O

When low, the parallel port data bus is not driving; when high, the port is in output

mode and is actively driving. PDBEN will toggle between the on and off states during

output modes and is only active (high) while the data bus pins are in the active driving

state. PDBEN can be logically connected to the enable control of 74245 (or equivalent)

bidirectional buffers (see Section 5.9 and Figure 11).

18

Datasheet

Share Link: