SL11RIDE Ver la hoja de datos (PDF) - Cypress Semiconductor

Número de pieza

componentes Descripción

Lista de partido

SL11RIDE

USB to IDE/ATAPI Solution

Cypress Semiconductor 

SL11RIDE

Where:

<Filename> is the output file without extension.

<filename.bin> is the output file with (.bin) extension.

Note:

This program is only used when the I2C is connected to the SL11RIDE chip.

Under Windows, if the EEPROM already has a version of the SL11RIDE firmware programmed, it will be necessary to remove

the Bulk-Only hard disk controller from the Device Manager before this program can be used.

After this program completes, at any subsequent boot up, the SL11RIDE firmware will automatically scan the I2C and load the

code from the I2C into internal/external RAM. However, if the I2C was corrupted, it sometimes causes an unexpected error on

USB communication ports.

6.2.3 How to use QTUI2C.EXE

The QTOOLS utilities are in directory C:\Program Files\ScanLogic\USB2IDE\bin.

• qtui2c zero.bin

; You need to erase all program from I2C each time you download a new program.

• qtui2c cidexxx.bin

; Program ATAPI and IDE firmware into I2C

7.0 Mass Production Download EEPROM (I2C)

7.1 ToHex

7.1.1 Overview

This program converts the Binary output file (. bin) to the INTEL HEX format. This INTEL HEX format will be used for programming

the PROM on the DATAIO.

7.1.2 Usage

TOHEX <infilespec.bin> <outfilespec [HEX]> [offset, default=0x0000] [h|l]

Where:

Infilespec.bin

is the Binary output file produced by the QTASM

Outfilespec.hex

is the INTEL HEX output file produced by the TOHEX program

Offset

is valid from 0x0000 to 0xFFFF. Default is 0x0000.

[h|l]

‘h’ is selected HIGH PROM output file. ‘l’ is selected LOW PROM output file. Without this input the

default INTEL HEX output file will be stored into the single 8-bit PROM.

7.1.3 Example

TOHEX

cidexxx.bin cidexxx.hex

; Create INTEL HEX format for ATAPI device

Document #: 38-08007 Rev. **

Page 10 of 27

Share Link: