TS3011 Ver la hoja de datos (PDF) - STMicroelectronics
Número de pieza
componentes Descripción
Lista de partido
TS3011 Datasheet PDF : 14 Pages
| |||
TS3011
Electrical characteristics
Table 5. VCC = +5 V, VICM = VCC/2, Tamb = +25°C (unless otherwise specified)(1)
Symbol
Parameter
Test conditions
Min. Typ. Max. Unit
VIO Input offset voltage(2)
ΔVIO Input offset voltage drift
VHYST Input hysteresis voltage(3)
IIO Input offset current(4)
-40°C < Tamb < +125°C
-40°C < Tamb < +125°C
-40°C < Tamb < +125°C
IIB Input bias current
ICC Supply current
ISC Short circuit current
-40°C < Tamb < +125°C
No load, output high
-40°C < Tamb < +125°C
No load, output low
-40°C < Tamb < +125°C
Source
Sink
VOH Output voltage high
VOL Output voltage low
CMRR Common mode rejection ratio
SVR Supply voltage rejection
TPLH
Propagation delay(5)
low to high output level
Isource = 4 mA
-40°C < Tamb < +125°C
Isink = 4 mA
-40°C < Tamb < +125°C
0 < VICM < 5 V
ΔVCC = 2.2 V to 5 V
CL = 12 pF, RL = 1 MΩ
Overdrive = 5 mV
Overdrive = 15 mV
Overdrive = 50 mV
TPHL
Propagation delay(6)
high to low output level
CL = 12 pF, RL = 1 MΩ
Overdrive = 5 mV
Overdrive = 15 mV
Overdrive = 50 mV
TR Rise time (10% to 90%)
CL = 12 pF, RL = 1 MΩ
Overdrive = 100 mV
TF Fall time (10% to 90%)
CL = 12 pF, RL = 1 MΩ
Overdrive = 100 mV
-7
-0.4
-9
10
2
1
1
0.47
0.60
58
62
58
64
4.84 4.89
4.80
90
57
74
79
7
9
mV
30 μV/°C
mV
20
100
pA
20
100
pA
0.69
0.9
mA
0.91
1.1
mA
V
120
180
mV
dB
14
10
ns
8
11
16
11
ns
9
12
1.1
ns
1.0
ns
1. All values over the temperature range are guaranteed through correlation and simulation. No production tests are
performed at the temperature range limits.
2. The offset is defined as the average value of positive (VTRIP+) and negative (VTRIP-) trip points (input voltage differences
requested to change the output state in each direction
3. Hysteresis is a built-in feature of the TS3011. It is defined as the voltage difference between the trip points.
4. Maximum values include unavoidable inaccuracies of the industrial tests.
5. Overdrive is measured with reference to the VTRIP+ point.
6. Overdrive is measured with reference to the VTRIP- point.
Doc ID 022078 Rev 1
5/14
Share Link: 