M105 Ver la hoja de datos (PDF) - STMicroelectronics
Número de pieza
componentes Descripción
Lista de partido
M105
STMicroelectronics
M105 Datasheet PDF : 9 Pages
| |||
TSM105
An example of a suitable compensation network is
shown in Fig.2. It consists of a capacitor
Cvc1=2.2nF and a resistor Rcv1=470KΩ in series,
connected in parallel with another capacitor
Cvc2=22pF.
The current-control trans-conductance operation-
al amplifier has to be compensated in a different
way, since its negative input is connected to
ground. A series connection of a capacitor
Cic1=100nF and a resistor Ric1=22Ω can be put
between OUT and GND to stabilize the global reg-
ulation loop.
3. Start Up and Short Circuit Conditions
Under start-up or short-circuit conditions the
TSM105 is not provided with a high enough supply
voltage. This is due to the fact that the chip has its
power supply line in common with the power sup-
ply line of the system.
Therefore, the current limitation can only be en-
sured by the primary PWM module, which should
be chosen accordingly.
Figure 4 :
If the primary current limitation is considered not to
be precise enough for the application, then a suffi-
cient supply for the TSM105 has to be ensured un-
der any condition. It would then be necessary to
add some circuitry to supply the chip with a sepa-
rate power line. This can be achieved in numer-
ous ways, including an additional winding on the
transformer.
The following schematic shows how to realise a
low-cost power supply for the TSM105 (with no
additional windings).
Please pay attention to the fact that in the particu-
lar case presented here, this low-cost power sup-
ply can reach voltages as high as twice the volt-
age of the regulated line. Since the Absolute Max-
imum Rating of the TSM105 supply voltage is 14
V, this low-cost auxiliary power supply can only be
used in applications where the regulated line volt-
age does not exceed 7 V.
Vcc
Rs
DS
CS + +
1.210V
TSM105
Vcc
+
Out
-
Vctrl
200mV
+
-
Gnd
Ictrl
Vsense
Rsense IL
D
To primary
R2
Rvc1
Cvc2470K
22pF
Cvc1
2.2nF
OUT+
IL
Cic1
+
100nF
Ric1
22
R1
OUT-
6/9
Share Link: