USB2502 Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

Lista de partido

USB2502

2-Port USB 2.0 Hub Controller

SMSC -> Microchip 

5.1.1.13

5.1.1.14

5.1.1.15

5.1.1.16

5.1.1.17

5.1.1.18

5.1.1.19

5.1.2

2-Port USB 2.0 Hub Controller

Datasheet

When Dynamic Power switching is enabled, the Hub detects the availability of a local power source

by monitoring the external SELF_PWR pin. If the Hub detects a change in power source availability,

the Hub immediately disconnects and removes power from all downstream devices and disconnects

the upstream port. The Hub will then re-attach to the upstream port as either a Bus-Powered Hub (if

local-power in unavailable) or a Self-Powered Hub (if local power is available).

This field is set by the OEM using either the SMBus or EEPROM interface options.

Over-Current Timer

The time delay (in 2ms increments) for an over-current condition to persist before it is reported to the

Host.

This field is set by the OEM using either the SMBus or EEPROM interface options.

Self-Powered Max Power

When in Self-Powered configuration, Sets value in 2mA increments.

This field is set by the OEM using either the SMBus or EEPROM interface options.

Bus-Powered Max Power

When in Bus-Powered configuration, Sets value in 2mA increments.

This field is set by the OEM using either the SMBus or EEPROM interface options.

Self-powered Hub Controller Current

When in Self-Powered configuration, Maximum current requirements of the Hub Controller in 2mA

increments.

This field is set by the OEM using either the SMBus or EEPROM interface options.

Bus-Powered Hub Controller Current

When in Bus-Powered configuration, Maximum current requirements of the Hub Controller in 2mA

increments.

This field is set by the OEM using either the SMBus or EEPROM interface options.

Power-On Timer

Time (in 2ms intervals) from the time power-on sequence begins on a port until power is good on that

port. System software uses this value to determine how long to wait before accessing a powered-on

port.

This field is set by the OEM using either the SMBus or EEPROM interface options.

Power Switching Polarity

The selection of active state “polarity” for the PRTPWR2 pin is made by a strapping option only.

VBus Detect

According to Section 7.2.1 of the USB 2.0 Specification, a downstream port can never provide power

to its D+ or D- pull-up resistors unless the upstream port’s VBUS is in the asserted (powered) state.

The VBUS_DET pin on the Hub monitors the state of the upstream VBUS signal and will not pull-up

the D+ or D- resistor if VBUS is not active. If VBUS goes from an active to an inactive state (Not

Powered), Hub will remove power from the D+ or D- pull-up resistor within 10 seconds.

Revision 2.3 (08-27-07)

18

DATASHEET

SMSC USB2502

Share Link: