W78E58 Ver la hoja de datos (PDF) - Winbond

Número de pieza

componentes Descripción

Lista de partido

W78E58

8-BIT MICROCONTROLLER

Winbond 

W78E58

emission if it is useless. Turning off the ALE signal transition only requires setting the bit 0 of the

AUXR SFR, which is located at 08Eh. When ALE is turned off, it will be reactivated when the program

accesses external ROM/RAM data or jumps to execute an external ROM code. The ALE signal will

turn off again after it has been completely accessed or the program returns to internal ROM code

space..

The AO bit in the AUXR register, when set, disables the ALE output.

***AUXR - Auxiliary register (8EH)

-

-

-

-

-

-

-

AO

AO: Turn off ALE output.

4. Power-off Flag

***PCON - Power control (87H)

SMOD

-

-

POF

GF1

GF0

PD

IDL

SMOD: Double baud rate bit. When set to a 1, the baud rate is doubled when the serial port is

being used in either modes 1, 2, 3.

POF:

Power off flag. Bit is set by hardware when power on reset. It can be cleared by software

to determine chip reset is a warm boot or cold boot.

GF1, GF0: These two bits are general-purpose flag bits for the user.

PD:

Power down mode bit. Set it to enter power down mode.

IDL:

Idle mode bit. Set it to enter idle mode.

The power-off flag is located at PCON.4. This bit is set when VDD has been applied to the part. It can

be used to determine if a reset is a warm boot or a cold boot if it is subsequently reset by software.

Flash Operations

In normal operation, the W78E58 is functionally compatible with the W78C58. In the flash operating

mode, the flash EEPROM can be programmed and verified repeatedly. Once the code inside the

flash EEPROM is confirmed, the code can be protected. The flash EEPROM and the operations on it

are described below.

All of the operations are configured by the pins RST, ALE, PSEN, A9CTRL (P3.0), A13CTRL (P3.1),

A14CTRL (P3.2), OECTRL (P3.3), CE (P3.6), OE (P3.7), A0 (P1.0) and VPP (EA ). In these

operations, A15 to A0 (P2.7 to P2.0, P1.7 to P1.0) and D7 to D0 (P0.7 to P0.0) serve as the address

and data bus, respectively.

Read Operation

This operation enables customers to read their codes and the option bits. The data will not be valid if

the lock bit is programmed to low.

- 10 -

Share Link: