ZLDO500 Ver la hoja de datos (PDF) - Zetex => Diodes
Número de pieza
componentes Descripción
Lista de partido
ZLDO500 Datasheet PDF : 9 Pages
| |||
ZLDO500
NOTES.
1. Maximum power dissipation of the device is calculated assuming the package is mounted on a
PCB measuring 2 inches square.
2 Output voltage temperature coefficient is calculated as:- VO change x 1000000
VO x temperature change
3. Dropout voltage is defined as the input to output voltage differential at which the circuit ceases
to regulate. The value is measured when the output voltage has dropped by 100mV from Vout
measured at the nominal input Vin = Vout + 1V
4. Guaranteed by design.
FUNCTIONAL DESCRIPTION
The ZLDO is a high performance, ultra low
dropout, low quiescent regulator. Available in
SM8 surface mount packaging, the device is
able to dissipate 2W(note 1) allowing
complete design flexibility with an input span
upto 20V and 300mA output current. The
device quiescent is 1mA (typ) at 300mA load
current. A low battery comparator signifies
impending battery failure, whilst a shutdown
function reduces quiescent current to a mere
11µA (typ). A precision bandgap reference
gives ± 2.5% output tolerance and good
temperature characteristics over the range
-40 to +85°C. AC performance is enhanced via
the use of a small external capacitor.
PIN DEFINITIONS
Pin 1 LBF - Low Battery Flag. An open
collector NPN output which pulls low on failing
input supply.
Pin 2 SC - Shutdown Control. This high
impedance logic compatible input disables the
regulator when taken high. It includes a diode
wired to Vin and so will pass current if taken
more than 0.5V above Vin.
Pin 3 Vin - Voltage Input. The power supply to
the regulator. The permissible input voltage
range is -0.3 to 20V. An input capacitor is not
mandatory but will be useful in reducing the
coupling of noise from input to output and
minimising the effect of sudden changes in load
current on the input voltage.
Pin 4 N/C - Not Connected. Not internally
connected and so can be left open or wired to
any pin without affecting the performance of the
regulator.
Pin 5 Vout - Voltage Output. The output of the
regulator. An output capacitor of 1uF or greater
and having low ESR should be wired in close
proximity to the regulator to ensure stability for
all loads.
Pin 6 D/C - Do Not Connect. This pin is wired
to an internal circuit node of the regulator. No
external connection should be made to this pin.
Pin 7 Gnd - Ground. The ground connection
of the regulator against which the output
voltage is referenced.
Pin 8 Spg - Shaping. The shaping node for
the error amplifier of the regulator. A
capacitor of 10pF wired from this pin to the
output pin (pin 5) gives optimum stability.
Improved AC can be achieved by reducing
the value of this capacitor but stability may
be impaired for some load conditions.
4-82
Share Link: 