LT1795ISW Ver la hoja de datos (PDF) - Linear Technology
Número de pieza
componentes Descripción
Lista de partido
LT1795ISW Datasheet PDF : 12 Pages
| |||
LT1795
APPLICATIONS INFORMATION
Figure 9 shows the effect of the network on a 200pF load.
Without the optional compensation, there is a 6dB peak at
85MHz caused by the effect of the capacitance on the
output stage. Adding a 0.01µF bypass capacitor between
the output and the COMP pins connects the compensation
14
12
VS = ±15V
CL = 200pF
10
8
RF = 1k
COMPENSATION
6
RF = 3.4k
NO
COMPENSATION
4
2
0
–2
RF = 3.4k
–4
COMPENSATION
–6
1
10
100
FREQUENCY (MHz)
Figure 9.
1795 F09
and greatly reduces the peaking. A lower value feedback
resistor can now be used, resulting in a response which is
flat to ±1dB to 45MHz. The network has the greatest effect
for CL in the range of 0pF to 1000pF.
Although the optional compensation works well with
capacitive loads, it simply reduces the bandwidth when it
is connected with resistive loads. For instance, with a 25Ω
load, the bandwidth drops from 48MHz to 32MHz when
the compensation is connected. Hence, the compensation
was made optional. To disconnect the optional compensa-
tion, leave the COMP pin open.
DEMO BOARD
A demo board (DC261A) is available for evaluating the
performence of the LT1795. The board is configured as a
differential line driver/receiver suitable for xDSL applica-
tions. For details, consult your local sales representative.
PACKAGE DESCRIPTIO Dimensions in inches (millimeters) unless otherwise noted.
SW Package
20-Lead Plastic Small Outline (Wide 0.300)
(LTC DWG # 05-08-1620)
0.496 – 0.512*
(12.598 – 13.005)
20 19 18 17 16 15 14 13 12 11
10
NOTE 1
0.394 – 0.419
(10.007 – 10.643)
0.291 – 0.299**
(7.391 – 7.595)
0.010
(0.254
–
–
0.029
0.737)
×
45°
1 2 3 4 5 6 7 8 9 10
0.093 – 0.104
(2.362 – 2.642)
0.037 – 0.045
(0.940 – 1.143)
0° – 8° TYP
0.050
0.009 – 0.013
(0.229 – 0.330)
NOTE:
NOTE 1
0.016 – 0.050
(0.406 – 1.270)
(1.270)
TYP
0.014 – 0.019
(0.356 – 0.482)
TYP
1. PIN 1 IDENT, NOTCH ON TOP AND CAVITIES ON THE BOTTOM OF PACKAGES ARE THE MANUFACTURING OPTIONS.
THE PART MAY BE SUPPLIED WITH OR WITHOUT ANY OF THE OPTIONS
*DIMENSION DOES NOT INCLUDE MOLD FLASH. MOLD FLASH SHALL NOT EXCEED 0.006" (0.152mm) PER SIDE
**DIMENSION DOES NOT INCLUDE INTERLEAD FLASH. INTERLEAD FLASH SHALL NOT EXCEED 0.010" (0.254mm) PER SIDE
0.004 – 0.012
(0.102 – 0.305)
S20 (WIDE) 0396
Share Link: 