datasheetbank_Logo
búsqueda de Hoja de datos y gratuito Fichas de descarga

PA7540 Ver la hoja de datos (PDF) - Anachip Corporation

Número de pieza
componentes Descripción
Lista de partido
PA7540 Datasheet PDF : 10 Pages
1 2 3 4 5 6 7 8 9 10
Figure 15. Sequential Timing – Waveforms and Block Diagram
Notes
1. Minimum DC input is -0.5V, however inputs may under-shoot to -2.0V
for periods less than 20ns.
2.Test points for Clock and VCC in tR,tF,tCL,tCH, and tRESET are referenced at
10% and 90% levels.
3. I/O pins are 0V or VCC.
4. Test one output at a time for a duration of less than 1 sec.
5. Capacitances are tested on a sample basis.
6. Test conditions assume: signal transition times of 5ns or less from the
10% and 90% points, timing reference levels of 1.5V (unless
otherwise specified).
7. tOE is measured from input transition to VREF ±0.1V (See test loads at
end of Section 6 for VREF value). tOD is measured from input transition
to VOH -0.1V or VOL +0.1V.
8. DIP: “System-clock” refers to pin 1/13 high speed clocks. PLCC: “Sys-
tem-clock” refers to pin 2/16 high speed clocks.
9. For T or JK registers in toggle (divide by 2) operation only.
10. For combinatorial and async-clock to LCC output delay.
11. ICC for a typical application: This parameter is tested with the device
programmed as a 10-bit D-type counter.
12. Test loads are specified in Section 5 of the Data Book.
13. “Async. Clock” refers to the clock from the Sum term (OR gate).
14. The “LCC” term indicates that the timing parameter is applied to the
LCC register. The “LCC/IOC” term indicates that the timing
parameter is applied to both the LCC and IOC registers.
16. The term “input” without any reference to another term refers to an
(external) input pin.
17. The parameter tSPI indicates that the PCLK signal to the IOC register
is always slower than the data from the pin or input by the absolute
value of (tSK -tPK -tIA). This means that no set-up time for the data
from the pin or input is required, i.e. the external data and clock can
be sent to the device simultaneously. Additionally, the data from the
pin must remain stable for tHPI time, i.e. to wait for the PCLK signal to
arrive at the IOC register.
18. Typical (typ) ICC is measured at TA = 25° C, freq = 25MHZ, VCC =
5V
9
04-02-051B

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]