PI3CH360(2006) Ver la hoja de datos (PDF) - Pericom Semiconductor

Número de pieza

componentes Descripción

Lista de partido

PI3CH360
(Rev.:2006)

Low Voltage, High-Bandwidth, 3-Channel 2:1 Mux/DeMux, NanoSwitch™

Pericom Semiconductor 

PI3CH360

Low Voltage, High-Bandwidth, 3-Channel, 2:1

Mux/DeMux, NanoSwitch™

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Storage Temperature ................................................ –65°C to +150°C

Ambient Temperature with Power Applied ............... –40°C to +85°C

Supply Voltage to Ground Potential ........................... –0.5V to +4.6V

DC Input Voltage ........................................................ –0.5V to +6.0V

DC Output Current................................................................... 120mA

Power Dissipation ....................................................................... 0.5W

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the device. This is a

stress rating only and functional operation of the device at these

or any other conditions above those indicated in the operational

sections of this specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may affect re-

liability.

DC Electrical Characteristics, 3.3V Supply (Over Operating Range, TA = –40°C to +85°C, VCC = 3.3V ± 10%)

Parameters

Description

Test Conditions(1)

Min. Typ.(2) Max. Units

VIH

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

VIL

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

0.8 V

VIK

Clamp Diode Voltage

VCC = Min., IIN = –18mA

–1.3 –1.8

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±1

IIL

IOZH

Input LOW Current

High-Impedence Current(3)

VCC = Max., VIN = GND

0 ≤ Y, In ≤ VCC

±1 µA

±1

RON

Switch On-Resistance(4)

VCC = Min.,VIN = 0.0V

ION = –48mA or –64mA

VCC = Min., VIN = 3.6V, ION = –15mA

4

6

Ω

5

8

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between Y and In pin at indicated current through the switch. ON resistance is determined

by the lower of the voltages on the two (Y, In) pins

06-0247

2

PS8727C

05/10/06

Share Link: