RS6515-ADSG Ver la hoja de datos (PDF) - Orister Corporation
Número de pieza
componentes Descripción
Lista de partido
RS6515-ADSG Datasheet PDF : 11 Pages
| |||
Page No. : 5/11
Detail Description
The RS6515 is a synchronous high voltage buck converter that can support the input voltage range from 4.75V to 20V and the
output current can be up to 2A.
Output Voltage Setting
The resistive divider allows the FB pin to sense the output voltage as shown in Figure 1.
Figure 1. Output Voltage Setting
The output voltage is set by an external resistive divider according to the following equation：
VOUT
VFB 1
R1
R2
Where VFB is the feedback reference voltage (0.92V typ.).
External Bootstrap Diode
Connect a 10nF low ESR ceramic capacitor between the BOOT pin and SW pin. This capacitor provides the gate driver voltage
for the high side MOSFET.
It is recommended to add an external bootstrap diode between an external 5V and the BOOT pin for efficiency improvement
when input voltage is lower than 5.5V or duty ratio is higher than 65%. The bootstrap diode can be a low cost one such as
1N4148 or BAT54.
Soft‐Start
The RS6515 contains an external soft‐start clamp that gradually raises the output voltage. The soft‐start timing can be
programmed by the external capacitor between SS pin and GND. The chip provides a 7μA charge current for the external
capacitor. If a 0.1μF capacitor is used to set the soft‐start and its period will be 13ms(typ.).
Inductor Selection
The inductor value and operating frequency determine the ripple current according to a specific input and output voltage.
The ripple current ΔIL increases with higher VIN and decreases with higher inductance.
I L
VOUT
f L
1
VOUT
VIN
Having a lower ripple current reduces not only the ESR losses in the output capacitors but also the output voltage ripple. High
frequency with small ripple current can achieve highest efficiency operation. However, it requires a large inductor to achieve
this goal.
For the ripple current selection, the value of ΔIL = 0.2375(IMAX) will be a reasonable starting point. The largest ripple current
occurs at the highest VIN. To guarantee that the ripple current stays below the specified maximum, the inductor value should
be chosen according to the following equation：
L
f
VOUT
IL(MAX
)
1
VOUT
VIN (MAX
)
DS‐RS6515‐08 JULY, 2010
www.Orister.com
Share Link: 