GS882Z36BD-166 Ver la hoja de datos (PDF) - Giga Semiconductor
Número de pieza
componentes Descripción
Lista de partido
GS882Z36BD-166 Datasheet PDF : 33 Pages
| |||
GS882Z18/36BB/D-250/225/200/166/150/133
Synchronous Truth Table
Operation
Type Address E1 E2 E3 ZZ ADV W Bx G CKE CK DQ Notes
Deselect Cycle, Power Down
D
None H X X L L X X X L L-H High-Z
Deselect Cycle, Power Down
D
None X X H L L X X X L L-H High-Z
Deselect Cycle, Power Down
D
None X L X L L X X X L L-H High-Z
Deselect Cycle, Continue
D
None X X X L H X X X L L-H High-Z 1
Read Cycle, Begin Burst
R External L H L L L H X L L L-H Q
Read Cycle, Continue Burst
B
Next X X X L H X X L L L-H Q 1,10
NOP/Read, Begin Burst
R External L H L L L H X H L L-H High-Z 2
Dummy Read, Continue Burst
B
Next X X X L H X X H L L-H High-Z 1,2,10
Write Cycle, Begin Burst
W External L H L L L L L X L L-H D
3
Write Cycle, Continue Burst
B
Next X X X L H X L X L L-H D 1,3,10
NOP/Write Abort, Begin Burst
W
None L H L L L L H X L L-H High-Z 2,3
Write Abort, Continue Burst
B
Next X X X L H X H X L L-H High-Z 1,2,3,10
Clock Edge Ignore, Stall
Current X X X L X X X X H L-H -
4
Sleep Mode
None X X X H X X X X X X High-Z
Notes:
1. Continue Burst cycles, whether Read or Write, use the same control inputs. A Deselect continue cycle can only be entered into if a
Deselect cycle is executed first.
2. Dummy Read and Write abort can be considered NOPs because the SRAM performs no operation. A Write abort occurs when the W pin
is sampled low but no Byte Write pins are active, so no write operation is performed.
3. G can be wired low to minimize the number of control signals provided to the SRAM. Output drivers will automatically turn off during write
cycles.
4. If CKE High occurs during a pipelined read cycle, the DQ bus will remain active (Low Z). If CKE High occurs during a write cycle, the bus
will remain in High Z.
5. X = Don’t Care; H = Logic High; L = Logic Low; Bx = High = All Byte Write signals are high; Bx = Low = One or more Byte/Write signals
are Low
6. All inputs, except G and ZZ must meet setup and hold times of rising clock edge.
7. Wait states can be inserted by setting CKE high.
8. This device contains circuitry that ensures all outputs are in High Z during power-up.
9. A 2-bit burst counter is incorporated.
10. The address counter is incriminated for all Burst continue cycles.
Rev: 1.00b 12/2002
8/33
© 2001, Giga Semiconductor, Inc.
Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.
Share Link: 