RMS Power Detector
1kΩ to avoid loading the RF input signal. There is an
internal resistor to GND of approximately 50kΩ. If the
control source high voltage is greater than 2.8V, calcu-
late and use a resistor value that ensures the ENA pin
only sees a maximum of 2.7V, which is within specifica-
tion. In this manner, the device can be driven from a
control device with a logic-high greater than 2.8V.
Evaluation Kit Information
MAX2202 EV kit gerber files, schematic, BOM, and
other updates are available on the MAX2202 product
page at Maxim’s website (www.maxim-ic.com).
Layout
The device is not particularly sensitive to the layout
since it only needs 3dBm for maximum output voltage.
However, there are two areas that need attention: the
GND pins and the supply bypassing. Connect the GND
pins to the PCB ground with a ground via as close as
possible, and bypass VCC to ground with a capacitor
as close as possible to the part.
PROCESS: BiCMOS
Chip Information
Package Information
For the latest package outline information and land pat-
terns (footprints), go to www.maxim-ic.com/packages.
Note that a “+”, “#”, or “-” in the package code indi-
cates RoHS status only. Package drawings may show a
different suffix character, but the drawing pertains to
the package regardless of RoHS status.
PACKAGE
TYPE
PACKAGE
CODE
OUTLINE NO.
6 WLP W61B1+1 21-0217
LAND
PATTERN NO.
Refer to
Application
Note 1891
_______________________________________________________________________________________ 7
Downloaded from: http://www.datasheetcatalog.com/