RTOP100(2004) Ver la hoja de datos (PDF) - Vishay Semiconductors

Número de pieza

componentes Descripción

Lista de partido

RTOP100
(Rev.:2004)

Power Resistors for Mounting onto a Heatsink Thick Film Technology

Vishay Semiconductors 

Power Resistors for Mounting onto a Heatsink

Thick Film Technology

RTOP

Vishay Sfernice

CHOICE OF HEATSINK

The user must choose the heatsink according to the working conditions of the component (power, room temperature).

Maximum working temperature must not exceed 125°C. The dissipated power is simply calculated by the following ratio:

P=

∆T

(1)

[RTH (j-c) + RTH (c-a)]

P: expressed in W

∆T: difference between maximum working temperature and room temperature.

RTH: (j-c): thermal resistance value measured between resistive layer and outer side of the resistor. It is the thermal

resistance of the component (see Table Special Features).

RTH: (c-a): thermal resistance value measured between outer side of the resistor and room temperature. It is the

thermal resistance of the heatsink depending on the heatsink itself (type, shape) and the quality of the fastening

device.

Example:

RTH: (c-a) for RTOP 200 power rating 130W at ambient temperature + 30°C.

Thermal resistance (see table 1) RTH (j-c): 0.5°C/W

∆T ≤ 125°C - 30°C - ≤ 95°C

RTH

(j-c)

+

RTH

(c-a)

=

∆T

P

= 95 = 0.73°C/W

130

RTH (j-c) ≤ 0.5°C/W

RTH (c-a) ≤ 0.73°C/W - 0.5°C/W ≤ 0.23°C/W

RECOMMENDATIONS FOR MOUNTING ONTO A HEATSINK

Surfaces in contact must be carefully cleaned.

The heatsink must have an acceptable flatness: from 0.05mm to 0.1mm/100mm.

Roughness of the heater must be around 6.3µm.

In order to improve thermal conductivity, surfaces in contact (alumina, heatsink) are laid on with a silicone grease (type SI 340

from Rhône-Poulenc or Dow 340 from Dow Corning).

Tightening torque on heater: 2 Nm

For the electrical connections, it is recommended to use M4 x 6 screws and if necessary a washer of 1mm thickness. The

recommended screw tightening torque is 1 Nm.

Document Number: 50045

Revision 14-Jan-04

For technical questions, contact sfer@vishay.com

www.vishay.com

29

Share Link: